Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: JUAN ELORSA RIOS

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of JUAN ELORSA RIOS in 6215 TULIP LN, DALLAS, TX 75230 (NAICS 238130). OSHA activity number 345135594.

Watch Juan Elorsa Rios — free Get an email when a new federal OSHA severe-injury report for Juan Elorsa Rios is published. One employer, no account, unsubscribe in one click.
Establishment
JUAN ELORSA RIOS
Site address
6215 TULIP LN
City
DALLAS
State
TX
ZIP
75230
Mailing
4735 W FRIO, DALLAS, TX 75216
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
3
Ownership type
A

2 citations on file for this inspection.

1926.501 B13

Serious Gravity 10 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $4096.00 · Current $2458.00 Reduced
29 CFR  1926.501(b)(13):"Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels was not protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Nor did the the employer demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer did not develop and implement a fall protection plan which met the requirements of paragraph (k) of 1926.502.  On or about 02/04/2021 employees of Juan Rios were working at height removing shingles and framing from a residential house under reconstruction, at a height of approximately 11 feet without the use of fall protection.
Recent events (2)
  • — I (S) $2457.6
  • — Z (S) $4096

1926.1053 B01

Serious Gravity 10 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $4096.00 · Current $2458.00 Reduced
29 CFR 1926.1053(b)(1): When portable ladders were used for access to an upper landing surface, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension was not possible because of the ladder's length, then the ladder was not secured at its top to a rigid support that will not deflect, and a grasping device, such as a grab rail, was not provided to assist employees in mounting and dismounting the ladder:    On or about January 5, 2021 employees of Juan Elorsa Rios were removing shingles and framing components from a residential house, utilizing an extension ladder which did not extend 3 feet above the roof landing, exposing employees to a fall hazard.
Recent events (2)
  • — I (S) $2457.6
  • — Z (S) $4096

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345135594.