Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: ZELAZNY CONSTUCTION CO.

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of ZELAZNY CONSTUCTION CO. in 450 S. HILL AVE, ELMHURST, IL 60126 (NAICS 238190). OSHA activity number 345150593.

Watch Zelazny Constuction CO. — free Get an email when a new federal OSHA severe-injury report for Zelazny Constuction CO. is published. One employer, no account, unsubscribe in one click.
Site address
450 S. HILL AVE
City
ELMHURST
State
IL
ZIP
60126
Mailing
218 BIRMINGHAM CT, ROSELLE, IL 60172
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238190
Employees
5
Ownership type
A

4 citations on file for this inspection.

1926.451 B01 I

Serious Gravity 10 1 instance 3 exposed
Issued
Penalty
Initial $4096.00 · Current $3000.00 Reduced
29 CFR 1926.451(b)(1)(i): Each platform unit (e.g., scaffold plank, fabricated plank, fabricated deck, or fabricated platform) was not installed so that the space between adjacent units and the space between the platform and the uprights were no more than 1 inch (2.5 cm) wide, except where the employer can demonstrate that a wider space is necessary.  On or about February 17, 2021, the employer failed to ensure that scaffold planks were fully planked and installed, exposing employees to fall hazards between 8 feet, 5 inches and 14 feet, 10 inches high while standing on a metal scaffold and performing construction activities.    No abatement certification or documentation is required for this item.
Recent events (2)
  • — I (S) $3000
  • — Z (S) $4096

1926.451 B03

Deleted Serious Gravity 5 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.451(b)(3): Except as provided in paragraphs (b)(3)(i) and (ii) of this section, the front edge of all platforms shall not be more than 14 inches (36 cm) from the face of the work, unless guardrail systems are erected along the front edge and/or personal fall arrest systems are used in accordance with paragraph (g) of this section to protect employees from falling.  On or about February 17, 2021, the employer failed to ensure that the front edge platforms were properly installed from the face of the work, exposing employees to fall hazards approximately 14 feet, 10 inches high while standing on a metal scaffold and performing construction activities.    Abatement documentation is required for this item in accordance with 29 CFR 1903.19(d).
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.451 G01

Serious Gravity 10 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $4096.00 · Current $0.00 Reduced
29 CFR 1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section.   On or about February 17, 2021, employees were exposed to fall hazards between 14 feet, 10 inches and 15 feet high while standing on a metal scaffold and performing construction activities.    Abatement documentation is required for this item in accordance with 29 CFR 1903.19(d).
Recent events (2)
  • — I (S) $0
  • — Z (S) $4096

1926.451 E01

Serious Gravity 5 1 instance 4 exposed
Issued
Abate by
Penalty
Initial $2926.00 · Current $1500.00 Reduced
29 CFR 1926.451(e)(1): When scaffold platforms are more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from another scaffold, structure, personnel hoist, or similar surface shall be used. Crossbraces shall not be used as a means of access.  On or about February 17, 2021, the employer failed to provide a proper ladder access, exposing employees to fall hazards between 14 feet, 10 inches and 15 feet high when accessing a metal scaffold to perform construction activities.    Abatement documentation is required for this item in accordance with 29 CFR 1903.19(d).
Recent events (2)
  • — I (S) $1500
  • — Z (S) $2926

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345150593.