OSHA Inspection: CASEWORK LOGIC, LLC.

Issued

2022-03-15 00:00:00

Abate by

2022-03-23 00:00:00

Penalty

Initial $5801.00 · Current $2901.00 Reduced

General-duty citation text

29 CFR  1910.213(c)(1): Circular handfed ripsaw(s) were not guarded by an automatically adjusting hood which completely enclosed that portion of the saw above the table and above the material being cut:  a) On or about February 24, 2022, and at times prior, workers were exposed to laceration and amputation hazards while operating a Delta X5 table saw that was missing a hood to cover the exposed blade.  b) On or about February 24, 2022, and at times prior, workers were exposed to laceration and amputation hazards while operating a Hammer K3 Winner table saw that was missing a hood to cover the exposed blade.

Issued

2022-03-15 00:00:00

Abate by

2022-03-23 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR  1910.213(c)(2): Hand-fed circular ripsaw(s) were not furnished with a spreader to prevent material from squeezing the saw or being thrown back on the operator:  a) On or about February 24, 2022, and at times prior, workers were exposed to impalement and blunt forces while operating a Delta X5 table saw to perform through cuts that was missing a spreader.  b) On or about February 24, 2022, and at times prior, workers were exposed to impalement and blunt forces while operating a Hammer K3 Winner table saw to perform through cuts that was missing a spreader.

Issued

2022-03-15 00:00:00

Abate by

2022-03-23 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR  1910.213(c)(3): Handfed ripsaws were not provided with non kickback fingers or dogs so located as to oppose the thrust or tendency of the saw to pick up the material or to throw it back toward the operator:  a) On or about February 24, 2022, and at times prior, workers were exposed to impalement and blunt forces while operating a Delta X5 table saw while the anti-kickback device was not installed.  b) On or about February 24, 2022, and at times prior, workers were exposed to impalement and blunt forces while operating a Hammer K3 Winner table saw while the anti-kickback device was not installed.

Issued

2022-03-15 00:00:00

Abate by

2022-04-01 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR  1910.178(q)(7): Industrial trucks were being placed in services after the examination showed condition(s) adversely affecting the safety of the vehicle:  a) On or about February 24, 2022, and at times prior, powered industrial truck, Chassis No. KCPH01P90093, was placed in service without identifying and correcting the inoperative horn and a missing liquified petroleum fuel tank strap latch.  b)  On or about February 24, 2022, and at times prior, powered industrial truck, Chassis No. KCPH02P201081, was placed in service without identifying and correcting a missing liquified petroleum fuel tank strap latch.