Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: ECSA QUALITY CONSTRUCTION, LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of ECSA QUALITY CONSTRUCTION, LLC in 5911 MAPLEVIEW DRIVE, MASON, OH 45040 (NAICS 238130). OSHA activity number 345911994.

Watch Ecsa Quality Construction, LLC — free Get an email when a new federal OSHA severe-injury report for Ecsa Quality Construction, LLC is published. One employer, no account, unsubscribe in one click.
Site address
5911 MAPLEVIEW DRIVE
City
MASON
State
OH
ZIP
45040
Mailing
12017 ALGIERS DR., CINCINNATI, OH 45246
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
4
Ownership type
A

4 citations on file for this inspection.

1926.501 B14

Serious Gravity 10 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $4351.00 · Current $1500.00 Reduced
29 CFR  1926.501(b)(14): Duty to have fall protection. "Wall openings." Each employee working on, at, above, or near wall openings (including those with chutes attached) where the outside bottom edge of the wall opening is 6 feet (1.8 m) or more above lower levels and the inside bottom edge of the wall opening is less than 39 inches (1.0 m) above the walking/working surface, shall be protected from falling by the use of a guardrail system, a safety net system, or a personal fall arrest system.  a) On or about 04/20/2022 an employee while helping other framers by reaching material through a window opening which the inside bottom edge of the wall opening was measure at 23 inches above the walking surface at a new residential structure, was exposed to a fall hazard of at least 19.7 ft. from the ground; while working with no fall protection system in place.
Recent events (2)
  • — I (S) $1500
  • — Z (S) $4351

1926.502 D15 I

Serious Gravity 10 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $4351.00 · Current $0.00 Reduced
29 CFR  1926.502(d)(15)(i): Anchorages used for attachment of personal fall arrest equipment shall be independent of any anchorage being used to support or suspend platforms and capable of supporting at least 5,000 pounds (22.2 kN) per employee attached, or shall be designed, installed, and used as follows: as part of a complete personal fall arrest system which maintains a safety factor of at least two   a) On or about 04/20/2022, the employer did not ensure that his employees were connected to proper anchor points. The height of the fall hazard was measure at 19.7 ft. from the ground in the frontside of the new residential structure.
Recent events (2)
  • — I (S) $0
  • — Z (S) $4351

1926.503 A01

Serious Gravity 10 1 instance 4 exposed
Issued
Abate by
Penalty
Initial $4351.00 · Current $0.00 Reduced
29 CFR 1926.503(a)(1): Training Program. The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.   a)       On or about 04/20/2022 employees have not been trained on fall protection systems and on hazards of falls, while working at heights measured at  19.7 ft. from the ground.
Recent events (2)
  • — I (S) $0
  • — Z (S) $4351

1926.501 B13

Repeat Gravity 10 1 instance 4 exposed
Issued
Abate by
Penalty
Initial $9571.00 · Current $5000.00 Reduced
29 CFR  1926.501(b)(13):"Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502.  Note: There is a presumption that it is feasible and will not create a greater hazard to implement at least one of the above-listed fall protection systems. Accordingly, the employer has the burden of establishing that it is appropriate to implement a fall protection plan which complies with 1926.502(k) for a particular workplace situation, in lieu of implementing any of those systems.  a.) On or about 04/20/2022,  employees were exposed to a 19.7 ft. fall hazard while framing a new residential structure without any means of conventional fall protection system in place.  The employer, ECSA Quality Construction, LLC, was previously cited for a violation of this occupational safety and health standard or its equivalent standard 29 CFR 1926.501(b)(13), which was contained in OSHA inspection number 1427904, citation number 1, item number 1 and was affirmed as a final order on 12/03/2019, with respect to a workplace located at 5463 Birch View Drive, Mason, OH 45040.
Recent events (2)
  • — I (R) $5000
  • — Z (R) $9571

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345911994.