OSHA Inspection: TODD MOSELEY DBA MOSELEY CONSTRUCTION

Issued

2022-08-24 00:00:00

Abate by

2022-09-06 00:00:00

Penalty

Initial $3108.00 · Current $0.00 Reduced

General-duty citation text

29 CFR  1926.304(h)(1): Each circular crosscut table saw was not guarded by a hood that meets all the requirements of paragraph (i)(1) of this section for hoods for circular ripsaws:  a) On July 13, 2022 and times prior employees used a 10-inch DeWalt table saw with the upper blade guard removed.  Note) Certification of corrective action is required for this item.

Issued

2022-08-24 00:00:00

Abate by

2022-09-06 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR  1926.304(i)(1): Each circular hand-fed ripsaw was not guarded by a hood which completely enclosed the portion of the saw above the table and that portion of the saw above the material being cut:  a) On July 13, 2022 and times prior employees used a 10 inch DeWalt table saw with the upper blade guard removed.  Note) Certification of corrective action is required for this item.

Issued

2022-08-24 00:00:00

Abate by

2022-08-30 00:00:00

Penalty

Initial $4351.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):   a) On July 13, 2022 and at times prior employees performing framing activities on a 8 in 12 pitched roof without fall protection were exposed to fall hazards over 20 feet to the ground and a concrete pad below.     Note) Certification and documentation of corrective action are required for these items.

Issued

2022-08-24 00:00:00

Abate by

2022-09-06 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR  1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards:  a) On July 13, 2022 and times prior employees performing framing activities without fall protection were exposed to fall hazards 20 feet and over.  The employees did not recognize the hazard or take action to minimize their exposure.   Note) Certification and documentation of corrective action are required for this item.

Issued

2022-08-24 00:00:00

Abate by

2022-09-20 00:00:00

Penalty

Initial $3108.00 · Current $0.00 Reduced

General-duty citation text

29 CFR  1926.451(c)(2)(iv): Front-end loaders and similar pieces of equipment were used to support scaffold platforms without being specifically designed by the manufacturer for such use:  a)  On July 13, 2022 and times prior employees performing framing activities used a JCB telehandler for fall protection and for access to/from the work area on the roof.    The telehandler had not been approved or designed by the manufacturer for this use.   Note) Abatement certification is required for this item.