Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: JJAM CONSTRUCTION INC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of JJAM CONSTRUCTION INC in 525 OAK TERRACE, ALTAMONTE SPRINGS, FL 32701 (NAICS 238160). OSHA activity number 346238686.

Watch Jjam Construction INC — free Get an email when a new federal OSHA severe-injury report for Jjam Construction INC is published. One employer, no account, unsubscribe in one click.
Site address
525 OAK TERRACE
City
ALTAMONTE SPRINGS
State
FL
ZIP
32701
Mailing
417 MAGNOLIA STREET, ALTAMONTE SPRINGS, FL 32701
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238160
Employees
12
Ownership type
A

2 citations on file for this inspection.

1926.501 B13

Serious Gravity 10 1 instance 6 exposed
Issued
Penalty
Initial $4688.00 · Current $2578.00 Reduced
29 CFR  1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b):  a). On or about September 20, 2022 six employees were stripping old roofing and flashing from the second floor of a two-story condominium unit and were not protected by any means of personal fall protection, guardrails, or safety nets exposing them to a falls in excess of 19 feet to the ground below.
Recent events (2)
  • — I (S) $2578.4
  • — Z (S) $4688

1926.404 B01 I

Serious Gravity 1 1 instance 2 exposed
Issued
Penalty
Initial $2678.00 · Current $1473.00 Reduced
29 CFR  1926.404(b)(1)(i): Employer did not use either ground fault circuit interrupters as specified in paragraph (b)(1)(ii) of this section, or an assured equipment grounding conductor program as specified in paragraph (b)(1)(iii) of this section to protect employees on construction sites.   a) Jobsite: Employees were using a RIGID brand 2hp, 30-gallon air compressor connected to a flexible power cord that did not maintain a ground connector pin, exposing employees to electrical shock hazards, on or about September 22, 2022.  b) Jobsite:  Employees were using a flexible temporary cord to energize the circular saw on the roof was damaged, causing the cord to be plugged in to an energized cord exposing the employee to electrical shock hazards, on or about September 22, 2022.
Recent events (2)
  • — I (S) $1472.9
  • — Z (S) $2678

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346238686.