Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: DAVID AYALA LOPEZ

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of DAVID AYALA LOPEZ in 1116 RIDGE RUNNER DRIVE, GEORGETOWN, TX 78628 (NAICS 238140). OSHA activity number 346255540.

Watch David Ayala Lopez — free Get an email when a new federal OSHA severe-injury report for David Ayala Lopez is published. One employer, no account, unsubscribe in one click.
Establishment
DAVID AYALA LOPEZ
Site address
1116 RIDGE RUNNER DRIVE
City
GEORGETOWN
State
TX
ZIP
78628
Mailing
1402 COUNTRY ROAD B, LEXINGTON, TX 78947
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238140
Employees
1
Ownership type
A

6 citations on file for this inspection.

1926.100 A

Serious Gravity 1 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $1865.00 · Current $1119.00 Reduced
29 CFR 1926.100(a): Employees working in areas where there is a possible danger of head injury from impact, or from falling or flying objects, or from electrical shock and burns, was not protected by protective helmets.  On or about September 30, 2022, an employee was assisting a bricklayer by performing task such as cutting bricks, tossing cut bricks to the bricklayer above and transporting cement mix to the bricklayer. The employee did not use a hard hat while bricklaying work was performed directly above them, exposing the employee to the hazard of being struck-by falling debris, tools and materials.
Recent events (2)
  • — I (S) $1119
  • — Z (S) $1865

1926.102 A02

Serious Gravity 1 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $1865.00 · Current $1119.00 Reduced
29 CFR 1926.102(a)(2): The employer did not ensure that each affected employee used eye protection that provided side protection when there is a hazard from flying objects.  On or about September 30, 2022, an employee used a Milwaukee Chop Saw to cut bricks without wearing appropriate eye protection, exposing the employee to the hazard of being struck in the eye(s) by flying debris or projectiles.
Recent events (2)
  • — I (S) $1119
  • — Z (S) $1865

1926.300 A

Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $2486.00 · Current $1492.00 Reduced
29 CFR 1926.300(a): Condition of tools. All hand and power tools and similar equipment, whether furnished by the employer or the employee, were not maintained in a safe condition.  On or about September 30, 2022, an employee operated a Milwaukee chop saw to cut bricks without a guard, exposing the employee construction hazards such as but not limited to; being struck by materials or lacerations from the exposed blade.
Recent events (2)
  • — I (S) $1491.6
  • — Z (S) $2486

1926.451 B01 I

Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $2486.00 · Current $1492.00 Reduced
29 CFR 1926.451(b)(1)(i): Each platform unit (e.g., scaffold plank, fabricated plank, fabricated deck, or fabricated platform) was not installed so that the space between adjacent units and the space between the platform and the uprights were no more than 1 inch (2.5 cm) wide, except where the employer can demonstrate that a wider space is necessary.  On or about September 30, 2022, an employee had been working from platforms on a scaffold where the planks were more than 1 inch wide, exposing the employee to a fall hazard of approximately 13 feet.
Recent events (2)
  • — I (S) $1491.6
  • — Z (S) $2486

1926.451 G01 VI

Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $2486.00 · Current $1492.00 Reduced
29 CFR 1926.451(g)(1)(vi): Each employee performing overhand bricklaying operations and/or related work from a supported scaffold was not protected from falling from all open sides and ends of the scaffold (except at the side next to the wall being laid) by the use of a personal fall arrest system or guardrail system (with minimum 200 pound toprail capacity).  On or about September 30, 2022, an employee had been performing overhead bricklaying operations on a supported scaffold without open sides and ends being protected, exposing the employee to the hazard of falling approximately 13 feet to the ground below.
Recent events (2)
  • — I (S) $1491.6
  • — Z (S) $2486

1926.451 E01

Other-than-serious 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from another scaffold, structure, personnel hoist, or similar surface was not used.  On or about September 19, 2022, employees accessed and egressed a supported scaffold by means of climbing the sides of the scaffold which did not contain an approved point of access, exposing the employee to the hazards of falling from a scaffold approximately 13 feet from the ground.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346255540.