Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,214Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: JOSE PICHARDO FABIAN

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of JOSE PICHARDO FABIAN in 1001 RICHFIELD CT., MIDLOTHIAN, TX 76065 (NAICS 238140). OSHA activity number 346677115.

Watch Jose Pichardo Fabian — free Get an email when a new federal OSHA severe-injury report for Jose Pichardo Fabian is published. One employer, no account, unsubscribe in one click.
Site address
1001 RICHFIELD CT.
City
MIDLOTHIAN
State
TX
ZIP
76065
Mailing
1208 N ANGLIN ST., CLEBURNE, TX 76031
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238140
Employees
5
Ownership type
A

5 citations on file for this inspection.

1926.451 B01

Serious Gravity 5 1 instance 4 exposed
Issued
Abate by
Penalty
Initial $2679.00 · Current $1607.00 Reduced
29 CFR  1926.451(b)(1):Each platform on all working levels of scaffolds was not fully planked or decked between the front uprights and the guardrail supports as specified in paragraphs 1926.451(b)(1)(i)-(ii).  On May 3, 2023, on the west side of the construction site, where employees working from a tubular welded frame scaffold that was not fully planked on all working levels were exposed to falling hazards.
Recent events (2)
  • — I (S) $1607.4
  • — Z (S) $2679

1926.451 H01

Serious Gravity 1 1 instance 4 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR  1926.451(h)(1): Each employee on a scaffold was not provided with additional protection from falling hand tools, debris, and other small objects through the installation of toe boards, screens, guardrail systems, or through the erection of debris nets, catch platforms, or canopy structures that contain or deflect the falling objects.  For falling objects too large, heavy or massive to be contained or deflected, the employer did not place and secure such potential falling objects away from the edge of the surface from which they could fall.   On May 3, 2023, on the west side of the construction site, where employees working from a tubular welded frame scaffold without toe boards being installed were exposed to falling objects hazards at lower levels.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.451 E01

Serious Gravity 5 1 instance 4 exposed
Issued
Abate by
Penalty
Initial $2679.00 · Current $1607.00 Reduced
29 CFR  1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, structure, personnel hoist, or similar surface was not used.  Crossbraces were used as a means of access.   On May 3, 2023, on the west side of the construction site, the employer did not provide a scaffold ladder where employees could access and egress the tubular welded frame scaffold safely exposing them to fall hazards up to 13 feet.
Recent events (2)
  • — I (S) $1607.4
  • — Z (S) $2679

1926.451 G01

Serious Gravity 5 1 instance 4 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR  1926.451(g)(1): Employees on scaffolds more than 10 feet (3.1 m) above a lower level were not protected from falling to that lower level by fall protection established in paragraphs (g)(1)(i)-(vii) of this section:   On May 3, 2023, on the west side of the construction site, employees were observed working from the second-tier tubular welded frame scaffold without a fall protective system while performing masonry work.  The employees were exposed to a fall hazard of 13 feet to the ground below.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.405 G02 IV

Other-than-serious 1 instance 4 exposed
Issued
Abate by
Penalty
Initial $376.00 · Current $226.00 Reduced
29 CFR  1926.405(g)(2)(iv): Flexible cords were not connected to devices and fittings so that strain relief is provided to prevent pull from being directly transmitted to joints or terminal screws.   On May 3, 2023, on the west side of the construction site, employees using an extension cord to energize a DeWalt skill saw to cut masonry material that had the outer sheathing pulled away exposing internal wiring were exposed to electrical shock hazard.
Recent events (2)
  • — I (O) $225.6
  • — Z (O) $376

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346677115.