OSHA Inspection: TRANSOM SYMPHONY OPCO, LLC DBA BEAUTY QUEST GROUP

Issued

2023-09-08 00:00:00

Abate by

2023-10-02 00:00:00

Penalty

Initial $12278.00 · Current $12278.00

General-duty citation text

29 CFR  1910.147(c)(4)(i): Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section:  On or about May 11, 2023, employees were exposed to unexpected start-up or release of stored energy while performing servicing and maintenance activities on the Cappers, and the employer did not developed procedures that were documented to control hazardous energy.

Issued

2023-09-08 00:00:00

Abate by

2023-09-25 00:00:00

Penalty

Initial $12278.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1910.147(d): The established procedure for the application of energy control (the lockout or tagout procedures) did not cover the actions listed in and was not done in sequence as required by 29 CFR 1910.147(d)(1)-(6):  On or about May 11, 2023, an employee was exposed to caught-in and amputation hazards when performing maintenance and servicing on the Capper, Line 13 because the employer did not cover the actions listed in and was not done in sequence as required by 29 CFR 1910.147(d)(1)-(6).   The maintenance employee was making adjustments on Line 13, and was not required to:  (1)	Know the type and magnitude of the energy, the hazards of the energy to be controlled, and the method or means to control the energy,  (2)	Turn off and shut down the machine,  (3)	Physically locate and operate energy isolating devices in such a manner as to isolate the machine or equipment from the energy source,  (4)	Affix lockout or tagout devices to each energy isolating device,  (5)	Following the application of lockout or tagout devices to energy isolating devices, all potentially hazardous stored or residual energy shall be relieved, disconnected, restrained, and otherwise rendered safe.  (6)	Prior to starting work on machines that have been locked out or tagged out, verify that isolation and deenergization of the machine or equipment have been accomplished.

Issued

2023-09-08 00:00:00

Penalty

Initial $9822.00 · Current $6875.00 Reduced

General-duty citation text

29 CFR 1910.303(g)(1): Sufficient access and working space was not provided and maintained about all electric equipment (operating at 600 volts, nominal, or less to ground) to permit ready and safe operation and maintenance of such equipment:  On or about May 16, 2023, employees were exposed to electrical shock because the electrical panels around the capper lines did not have sufficient access and working space, as indicated in Table S-1.