Safety Incidents OSHA Severe Injury Reports · 2015–2025
2,004,209Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: EXTREME MANUFACTURING LLC

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of EXTREME MANUFACTURING LLC in 1909 NORTHEAST 25TH AVENUE, OCALA, FL 34470 (NAICS 325510). OSHA activity number 346735806.

Watch Extreme Manufacturing LLC — free Get an email when a new federal OSHA severe-injury report for Extreme Manufacturing LLC is published. One employer, no account, unsubscribe in one click.
Site address
1909 NORTHEAST 25TH AVENUE
City
OCALA
State
FL
ZIP
34470
Mailing
PO BOX 216, OCALA, FL 34478
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
325510
Employees
28
Ownership type
A

4 citations on file for this inspection.

1910.22 A01

Serious Gravity 1 2 instances 34 exposed
Issued
Abate by
Penalty
Initial $4687.00 · Current $2812.00 Reduced
29 CFR  1910.22(a)(1):  The employer did not ensure that all places of employment, passageways, storerooms, service rooms, and walking-working surfaces are kept in a clean, orderly, and sanitary condition.   a) At 1909 Northeast 25th Avenue, Ocala, FL:  On or about May 30, 2023 the employer exposed employees to  health hazards, in that, employees were using a restroom that is not in sanitary conditions.  b) At 1909 Northeast 25th Avenue, Ocala, FL: On or about May 30, 2023 the employer exposed employees to slip and fall hazards, in that, employees are exposed to aluminum shaving particles on the floor next to two aluminum saw stations.
Recent events (2)
  • — I (S) $2812.2
  • — Z (S) $4687

1910.22 D02

Serious Gravity 5 8 instances 34 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1910.22(d)(2): The employer did not ensure that hazardous conditions on walking-working surfaces are corrected or repaired before an employee uses the walking-working surface again. The employer did not ensure that if the correction or repair cannot be made immediately, the hazard is guarded to prevent employees from using the walking-working surface until the hazard is corrected or repaired.  a) At the trailers' assembly lines:  On or about May 30, 2023: the employer exposed employees to trip and  fall hazards, in that, the walking-working surface was not maintained free of holes. At the trailers assembly lines there was a floor hole 12" x 18" , set of six holes, 4 inches diameter each and wires exposed over concrete floor surface.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.215 B01

Serious Gravity 1 2 instances 34 exposed
Issued
Abate by
Penalty
Initial $4687.00 · Current $2812.00 Reduced
29 CFR  1910.215(b)(1): Cup wheel(s) of grinder(s) were not protected by guards.  a) At the trailers' assembly line:  On or about May 30, 2023, the employer exposed employees  to amputation hazards, in that, two grinders were used without guards.
Recent events (2)
  • — I (S) $2812.2
  • — Z (S) $4687

1910.101 C

Other-than-serious 1 instance 34 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR  1910.101(c):Compressed gas cylinders, portable tanks, and cargo tanks did not have pressure relief devices installed and maintained in accordance with Compressed Gas Association Pamphlets S-1.1-1963 and 1965 addenda and S-1.2-1963.  At 1909 Northeast 25th Avenue, Ocala, FL:  On or about May 30, 2023 the employer exposed employees to  struck-by hazards, in that, employer store Argon cylinders not secure at the assembly line area next to a door.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

View EXTREME MANUFACTURING LLC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 346735806.