Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: DESIGNING CONCRETE INC

Planned inspection · Health discipline

On , OSHA opened a planned health inspection of DESIGNING CONCRETE INC in 244 VILLAGE CT, PALATINE, IL 60067 (NAICS 561730). OSHA activity number 347428666.

Watch Designing Concrete INC — free Get an email when a new federal OSHA severe-injury report for Designing Concrete INC is published. One employer, no account, unsubscribe in one click.
Site address
244 VILLAGE CT
City
PALATINE
State
IL
ZIP
60067
Mailing
1086 LAKE AVENUE, WOODSTOCK, IL 60098
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Health
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
561730
Employees
5
Ownership type
A

7 citations on file for this inspection.

1910.134 C01

Serious Gravity 10 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $6452.00 · Current $3400.00 Reduced

Hazardous substances S103

29 CFR  1910.134(c)(1):A written respiratory protection program that included the provisions in 29 CFR 1910.134(c)(1)(i) - (ix) with worksite specific procedures was not established and implemented for required respirator use: (Construction Reference 1926.103)  a) On or about April 22, 2024, the employer did not ensure that a written respiratory protection program was established for employees required to wear respiratory protection, including 3M 7503 half -face negative pressure respirators, when grinding concrete on the stairs located at the west and east side of the property.
Recent events (2)
  • — I (S) $3400
  • — Z (S) $6452

1910.134 E01

Serious Gravity 10 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR  1910.134(e)(1): The employer did not provide a medical evaluation to determine the employee's ability to use a respirator, before the employee was fit tested or required to use the respirator in the workplace:   a)On or about April 22, 2024, Designing Concrete Inc did not provide medical evaluations to determine employees' ability to wear a tight-fitting negative pressure respirator before it was used.  Employees were required to wear a 3M 7503 half-face respirator while grinding concrete stairs.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1910.134 F02

Serious Gravity 10 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00

Hazardous substances S103

29 CFR  1910.134(f)(2): Employee(s) using tight-fitting facepiece respirators were not fit tested prior to initial use of the respirator:  a)  On or about April 22, 2024 at the above-addressed jobsite, the employer did not ensure that employees using tight-fitting facepiece respirators were fit tested prior to initial use of the respirator. Employees were required to use a 3M 7503 half-face respirator when grinding concrete.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.416 E01

Serious Gravity 5 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $3687.00 · Current $1500.00 Reduced
29 CFR  1926.416(e)(1):Worn or frayed electric cords were used.  a) On or about April 22, 2024 at the above-addressed job site, extension cords that were used by employees to power hand tools had been damaged and lacked insulation.
Recent events (2)
  • — I (S) $1500
  • — Z (S) $3687

1926.1153 C01

Serious Gravity 10 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $6452.00 · Current $3400.00 Reduced

Hazardous substances S103

29 CFR  1926.1153(c)(1): For each employee engaged in a task identified in Table 1, the employer did not fully and properly implement the engineering controls, work practices, and respiratory protection specified for the task on Table 1, unless the employer assesses and limits the exposure of the employee to respirable crystalline silica in accordance with paragraph (d) of this section.  On or about April 22, 2024, at the above addressed job site, the employer did not fully and properly implement engineering controls and work practices, as specified in Table 1 when using a Metabo WEV- 15-125 HT angle grinder to grind concrete containing up to 6 percent of respirable crystalline silica (Quartz) without equipping the tool with a water delivery system that supplies a continuous stream or spray of water at the point of impact.
Recent events (2)
  • — I (S) $3400
  • — Z (S) $6452

1926.1153 D02 I

Serious Gravity 10 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00

Hazardous substances S103

29 CFR  1926.1153(d)(2)(i): The employer did not assess the exposure of each employee who was or may reasonably be expected to be exposed to respirable crystalline silica at or above the action level in accordance with either the performance option in paragraph (d)(2)(ii) or the scheduled monitoring option in paragraph (d)(2)(iii) of this section:  a) On or about April 22, 2024, at the above-addressed jobsite, the employer did not assess the exposure of employees grinding the concrete stairs of the property containing up to 6 percent of respirable crystalline silica (Quartz).
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.1153 I02 I

Serious Gravity 10 1 instance 5 exposed
Issued
Abate by
Penalty
Initial $6452.00 · Current $0.00 Reduced

Hazardous substances S103

29 CFR  1926.1153(i)(2)(i):The employer did not ensure that each covered employee could demonstrate knowledge and understanding of at least the information contained in paragraphs (A) - (F) of this section.  a) On or about  April 22,  2024,  at the above mentioned addressed jobsite the employer did not ensure that each employee was trained on the health hazards associated with silica, specific tasks where exposure could occur, protective measures including respiratory protection, work practices, and engineering controls, and the identity of the competent person. Employees were exposed to crystalline silica when cutting bricks containing up to 6% crystalline silica (Quartz).
Recent events (2)
  • — I (S) $0
  • — Z (S) $6452

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347428666.