CELINA, TX —
OSHA Inspection: JULCAN ROOFING
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of JULCAN ROOFING in 2808 MATHIS DR., CELINA, TX 75009 (NAICS 238160). OSHA activity number 347464372.
Where did this inspection happen?
- Establishment
- JULCAN ROOFING
- Site address
- 2808 MATHIS DR.
- City
- CELINA
- State
- TX
- ZIP
- 75009
- Mailing
- 1003 SHADY LN, SEAGOVILLE, TX 75159
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238160
- Employees
- 4
- Ownership type
- A
Citations
5 citations on file for this inspection.
1926.501 B13
- Issued
- Abate by
- Penalty
- Initial $3457.00 · Current $2074.00 Reduced
General-duty citation text
29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501 (b): On or about May 7, 2024, and at times prior thereto, at the jobsite, employee(s) were engaged in applying roofing materials without adequate fall protection.
Recent events (2)
- — I (S) $2074.2
- — Z (S) $3457
1926.502 D
- Issued
- Abate by
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1926.502(d): The employer used body belts as part of a personal fall arrest system: Effective January 1, 1998, body belts are not acceptable as part of a personal fall arrest system. Note: The use of a body belt in a positioning device system is acceptable and is regulated under paragraph (e) of this section. On or about May 7, 2024, and at times prior thereto, employees performing roofing work were not wearing the correct harnesses for the personal fall arrest systems. The employer provided positioning device body belts that are not part of the personal fall protection systems.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1926.503 A01
- Issued
- Abate by
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards: On or about May 7, 2024, and at times prior thereto, at the jobsite, employee(s) were engaged in applying roofing materials without hazard recognition and avoidance training through fall protection program.
Recent events (2)
- — I (O) $0
- — Z (O) $0
1926.1053 B01
- Issued
- Abate by
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1926.1053(b)(1): Where (a) portable ladder(s) was/were used for access to an upper level landing surface and the ladder's length did not allow the ladder side rails to extend at least 3 feet (0.9 m) above the upper landing surface being accessed, the ladder was not secured at its top to a rigid support that will not deflect, and/or a grasping device was not provided to assist employees in mounting and dismounting the ladder. On or about May 7, 2024, and at times prior thereto, the employer did not ensure employees safely used the ladder to gain access to the residential roof. The ladder was not secured at the top and did not extend three feet above the landing surface. Employees were exposed to a fall hazard of approximately 11 feet.
Recent events (2)
- — I (O) $0
- — Z (O) $0
1926.1060 A
- Issued
- Abate by
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1926.1060(a): The employer did not provide a training program for each employee using ladders and stairways, as necessary, which would enable each employee to recognize hazards related to ladders and stairways and train each employee in the procedures to be followed to minimize these hazards.(a) (LOCATION) (IDENTIFY SPECIFIC OPERATIONS(S) AND/OR CONDITIONS)Note: 29 CFR 1926.21(b)(2) may be cited as an additional violation to support this requirement. On or about May 7, 2024, and at times prior thereto, at the jobsite, employee(s) utilizing ladders to access upper landing surfaces were not provided a training program with formal training to understand how to recognize and avoid hazards.
Recent events (2)
- — I (O) $0
- — Z (O) $0
More inspections in this industry (NAICS 238160)
FAIRVIEW, TN—2026-07-16
MARVIN PINERA
CARSON CITY, NV—2026-07-16
UNKNOWN/INVALID ESTABLISHMENT
BANNOCKBURN, IL—2026-07-16
ROOFING H.P. LLC
LOXLEY, AL—2026-07-16
CARLOS CHE
BALTIMORE, MD—2026-07-16
VAL CONSTRUCTION INC
More inspections in TX
WICHITA FALLS, TX—2026-07-16
UNITED RENTALS, INC.
SAN MARCOS, TX—2026-07-16
CASA MECHANICAL SERVICES, LTD.
CLARKSVILLE, TX—2026-07-15
SEQUOIAS TREE EXPERT LLC
EL PASO, TX—2026-07-15
SURE STEEL
CORPUS CHRISTI, TX—2026-07-15
NORTH STAR ENERGY SOLUTIONS LLC
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347464372.