DOTHAN, AL —
OSHA Inspection: WOODHAM'S CABINET SHOP, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of WOODHAM'S CABINET SHOP, INC. in 8252 U.S. 84, DOTHAN, AL 36305 (NAICS 337110). OSHA activity number 347577371.
Where did this inspection happen?
- Establishment
- WOODHAM'S CABINET SHOP, INC.
- Site address
- 8252 U.S. 84
- City
- DOTHAN
- State
- AL
- ZIP
- 36305
- Mailing
- 8252 U.S. 84, DOTHAN, AL 36305
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 337110
- Employees
- 15
- Ownership type
- A
Citations
12 citations on file for this inspection.
5(a)(1)
- Issued
- Abate by
- Penalty
- Initial $4610.00 · Current $2766.00 Reduced
General-duty citation text
OSH ACT of 1970 Section (5)(a)(1):The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to crushing hazards. a) Facility-wide; On or about June 25, 2024 and times prior employees were exposed to crush hazards in that the employer allowed employees to operate powered industrial trucks which did not have seatbelts installed.
Recent events (2)
- — I (S) $2766
- — Z (S) $4610
1910.22 A01
- Issued
- Abate by
- Penalty
- Initial $2765.00 · Current $1659.00 Reduced
E101M102
General-duty citation text
29 CFR 1910.22(a)(1): All places of employment, passageways, storerooms, and service rooms shall be kept clean and orderly and in a sanitary condition. a) Shop 2; On or about June 25, 2024 and at times prior the employer exposed employees to fire hazards in that employees were allowed to work in areas where combustible dust had accumulated on work surfaces in areas such as, but not limited to, the miter saw area.
Recent events (2)
- — I (S) $1659
- — Z (S) $2765
1910.147 C04 I
- Issued
- Abate by
- Penalty
- Initial $4610.00 · Current $2766.00 Reduced
General-duty citation text
29 CFR 1910.147(c)(4)(i):Procedures were not developed, documented and utilized for the control of potentially hazardous energy when employees were engaged in activities covered by this section: a)Shop 2; On or about June 25, 2024 and times prior employees were exposed to amputation hazards in that the employer failed to ensure procedures were developed, documented and utilized for the control of potentially hazardous energy for employees performing maintenance tasks on equipment such as, but not limited to, the SCMI Superset XL Moulding machine.
Recent events (2)
- — I (S) $2766
- — Z (S) $4610
1910.147 C07 I A
- Issued
- Abate by
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1910.147(c)(7)(i)(A):Authorized employee(s) did not receive training in the recognition of applicable hazardous energy sources, the type and magnitude of the energy available in the workplace, and the methods and means necessary for energy isolation. a) Shop 2; On or about June 25, 2024 and times prior employees were exposed to amputation hazards in that the employer failed to ensure authorized employees received training on the methods and means necessary for energy isolation for maintenance tasks on equipment such as, but not limited to, the SCMI Superset XL Moulding machine.
Recent events (2)
- — I (S) $0
- — Z (S) $0
1910.213 D01
- Issued
- Abate by
- Penalty
- Initial $2765.00 · Current $1659.00 Reduced
General-duty citation text
29 CFR 1910.213(d)(1):Circular handfed crosscut table saw(s) were not guarded by an automatically adjusting hood which completely enclosed that portion of the saw above the table and above the material being cut: a) Shop 1; On or about June 25, 2024 and times prior employees were exposed to cut-by hazards in that the employer allowed employees to operate an unguarded Sawstop table saw. b) Shop 2; On or about June 25, 2024 and times prior employees were exposed to cut-by hazards in that the employer allowed employees to operate an unguarded Sawstop table saw.
Recent events (2)
- — I (S) $1659
- — Z (S) $2765
1910.132 D02
- Issued
- Abate by
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1910.132(d)(2):The employer did not verify, through a written certification, that the required workplace hazard assessment had been performed: a) Facility-wide; On or about June 25, 2024 and times prior the employer failed to verify that the required workplace hazard assessment had been performed through a written certification that identified the workplace evaluated, the person certifying that the evaluation had been performed, the date(s) of the hazard assessment, and which identified the document as a certification of hazard assessment.
Recent events (2)
- — I (O) $0
- — Z (O) $0
1910.178 L01 I
- Issued
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1910.178(l)(1)(i):The employer did not ensure that each powered industrial truck operator is competent to operate a powered industrial truck safely, as demonstrated by the successful completion of the training and evaluation specified in this paragraph (l): a) Facility-wide; On or about June 25, 2024 and times prior the employer failed to ensure employees required to operate powered industrial trucks were competent to operate a powered industrial truck safely through the successful completion of the training and evaluation specified in paragraph (l).
Recent events (2)
- — I (O) $0
- — Z (O) $0
1910.305 G01 IV A
- Issued
- Abate by
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1910.305(g)(1)(iv)(A):Flexible cords and/or cables were used as a substitute for the fixed wiring of a structure: a) Shop 2; On or about June 25, 2024 and times prior the employer utilized flexible cords as a substitute for fixed wiring to provide power to a DeWalt Miter Saw.
Recent events (2)
- — I (O) $0
- — Z (O) $0
1910.1200 E01 I
- Issued
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1910.1200(e)(1)(i):The employer did not compile a list of the hazardous chemicals known to be present using a product identifier that was referenced on the appropriate safety data sheet. a) Shop 1; On or about June 25, 2024 and times prior the employer failed to ensure a list of hazardous chemicals was compiled for chemicals present in the facility.
Recent events (2)
- — I (O) $0
- — Z (O) $0
1910.1200 F06
- Issued
- Abate by
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1910.1200(f)(6):The employer did not ensure that each container of hazardous chemicals in the workplace was labeled, tagged or marked with the information specified under paragraphs (f)(6)(i) through (ii) of this section: a) Shop 1; On or about June 26, 2024 and times prior the employer failed to ensure chemicals such as, but not limited to, Lacquer Thinner were labeled, tagged or marked with information regarding the physical and health hazards of the chemical.
Recent events (2)
- — I (O) $0
- — Z (O) $0
1910.1200 G01
- Issued
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1910.1200(g)(1): Employers did not have a safety data sheet in the workplace for each hazardous chemical which they use. a) Facility-wide; On or about June 25, 2024 and times prior the employer failed to ensure safety data sheets were provided for hazardous chemicals used in the facility such as, but not limited to, High Heat Canister Adhesive and Lacquer Thinner.
Recent events (2)
- — I (O) $0
- — Z (O) $0
1910.1200 H01
- Issued
- Penalty
- Initial $0.00 · Current $0.00
General-duty citation text
29 CFR 1910.1200(h)(1):Employees were not provided effective information and training on hazardous chemicals in their work area at the time of their initial assignment and whenever a new hazard that the employees had not been previously trained about was introduced into their work area: a) Facility-wide; On or about June 25, 2024 and times prior the employer failed to provide effective information and training on hazardous chemicals such as, but not limited to, High Heat Canister Adhesive and Lacquer Thinner, to employees who will use the chemicals.
Recent events (2)
- — I (O) $0
- — Z (O) $0
More inspections in this industry (NAICS 337110)
OAKLAND PARK, FL—2026-07-16
PKB CABINETRY
ORLANDO, FL—2026-07-15
ROSTOV, LLC
RICHMOND HILL, GA—2026-07-14
WILSON CABINETRY, LLC
VESTAL, NY—2026-07-08
BARNWOOD KITCHEN CABINETS
DEERWOOD, MN—2026-07-02
111522 - DUFFNEY CUSTOM CABINETS LLC
More inspections in AL
FAIRHOPE, AL—2026-07-16
FRANCISCO ARES
LOXLEY, AL—2026-07-16
CARLOS CHE
TRUSSVILLE, AL—2026-07-16
ALL SOUTH STEELWORX, LLC
CLANTON, AL—2026-07-14
C & S CANOPY, INC.
BIRMINGHAM, AL—2026-07-14
SCHOLAR CRAFT PRODUCTS, INC.
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347577371.