Safety Incidents OSHA Severe Injury Reports · 2015–2025
4,113,118Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: CDH FINISH CARPENTRY LLC

Planned inspection · Safety discipline

On , OSHA opened a planned safety inspection of CDH FINISH CARPENTRY LLC in W6976 CRESTFIELD WAY, GREENVILLE, WI 54942 (NAICS 238350). OSHA activity number 347686636.

Watch CDH Finish Carpentry LLC — free Get an email when a new federal OSHA severe-injury report for CDH Finish Carpentry LLC is published. One employer, no account, unsubscribe in one click.
Site address
W6976 CRESTFIELD WAY
City
GREENVILLE
State
WI
ZIP
54942
Mailing
6049 CEDAR STREET, ABRAMS, WI 54101
Inspection type
Planned (H)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238350
Employees
2
Ownership type
A

4 citations on file for this inspection.

1926.102 A01

Deleted Serious Gravity 1 1 instance 1 exposed
Issued
Penalty
Initial $2074.00 · Current $0.00 Reduced
29 CFR  1926.102(a)(1): The employer shall ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation.   On or about August 14, 2024, at W6976 Crestfield Way in Greenville, Wisconsin, an employee was exposed to potential struck-by hazards operating a battery powdered impact driver tool without using eye protection.
Recent events (2)
  • — I (S) $0
  • — Z (S) $2074

1926.501 B13

Deleted Serious Gravity 5 1 instance 1 exposed
Issued
Penalty
Initial $3457.00 · Current $0.00 Reduced
29 CFR  1926.501(b)(13):  "Residential construction."  Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure.  On or about August 14, 2024, at W6976 Crestfield Way in Greenville, Wisconsin, an employee was exposed to a fall hazard while working from a roof 11 feet above surface level without using required fall protection equipment.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3457

1926.503 A01

Deleted Serious Gravity 5 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR  1926.503(a)(1): The employer shall provide a training program for each employee who might be exposed to fall hazards. The program shall enable each employee to recognize the hazards of falling and shall train each employee in the procedures to be followed in order to minimize these hazards.   On or about August 14, 2024, at W6976 Crestfield Way in Greenville, Wisconsin, the employer did not provide required fall protection safety training for an employee working at heights greater than six feet.  Employees was installing second floor windows from a roof surface.
Recent events (2)
  • — I (S) $0
  • — Z (S) $0

1926.1053 B01

Deleted Serious Gravity 5 1 instance 1 exposed
Issued
Penalty
Initial $3457.00 · Current $0.00 Reduced
29 CFR  1926.1053(b)(1):  Stairways and Ladders.  When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access.  On or about August 14, 2024, at W6976 Crestfield Way in Greenville, Wisconsin, an employee was exposed to a fall hazard using a roof access/egress ladder 11 feet above surface level without the siderails extended at least three feet above the roof surface.  Ladder side rails extended 24 inches above the roof surface.
Recent events (2)
  • — I (S) $0
  • — Z (S) $3457

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 347686636.