2,004,209Inspections Most recent open 2026-07-13 Last loaded 2026-07-17
Safety Incidents OSHA Severe Injury Reports · 2015–2025

OSHA Inspection: TRANSEDGE TRUCK CENTERS

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of TRANSEDGE TRUCK CENTERS in 1407 BULLDOG DRIVE, ALLENTOWN, PA 18104 (NAICS 423110). OSHA activity number 348077561.

Watch Transedge Truck Centers — free Get an email when a new federal OSHA severe-injury report for Transedge Truck Centers is published. One employer, no account, unsubscribe in one click.
Site address
1407 BULLDOG DRIVE
City
ALLENTOWN
State
PA
ZIP
18104
Mailing
1407 BULLDOG DRIVE, ALLENTOWN, PA 18104
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
A
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
423110
Employees
50
Ownership type
A

3 citations on file for this inspection.

1910.178 O01

Serious Gravity 5 1 instance 2 exposed
Issued
Penalty
Initial $8511.00 · Current $6383.00 Reduced
29 CFR  1910.178(o)(1):The employer did not ensure that only stable or safely arranged loads were handled:  a)  1407 Bulldog Dr. Allentown Pa, Shop Area - On or about March 3, 2025, Employees utilize a forklift that is under capacity for the task of moving tractor trucks, causing the forklift's counterweighted rear to raise off the ground.  This condition exposes employee to a roll over hazard.
Recent events (2)
  • — I (S) $6383.25
  • — Z (S) $8511

1910.179 J01 II

Serious Gravity 5 3 instances 3 exposed
Issued
Penalty
Initial $8511.00 · Current $6383.00 Reduced
29 CFR  1910.179(j)(1)(ii):The employer did not perform frequent and periodic inspections as defined in paragraphs (a) and (b) of this section:  a)   1407 Bulldog Dr Allentown - On or about March 3, 2025, Employees are utilizing a 5 ton overhead crane to install LNG tanks onto trucks.  The employer has no inspection history for the overhead crane.  b)   1407 Bulldog Dr Allentown - On or about March 3, 2025, Employees are utilizing a 5 ton crane with a spreader beam to hoist truck parts.  The spreader beam does not indicate its maximum working load limit and the employer has no inspection history for the device.  c)  1407 Bulldog Dr Allentown - On or about March 3, 2025, Employees utilize a 5 ton and 2 ton overhead crane to hoist truck parts.  The overhead cranes do not have their load limits indicated so that they may be observed from the shop floor.
Recent events (2)
  • — I (S) $6383.25
  • — Z (S) $8511

1910.132 D01

Other-than-serious 1 instance 2 exposed
Issued
Penalty
Initial $0.00 · Current $0.00
29 CFR  1910.132(d)(1):The employer did not assess the workplace to determine if hazards are present, or are likely to be present, which necessitate the use of personal protective equipment (PPE).  a)  1407 Bulldog Dr. Allentown Pa, Shop Area - On or about March 3, 2025, Employees utilize a 5 ton crane to place LNG tanks onto truck bodies.  The task places the employees near the suspended while being lowered into place.  The employer did not assess the workplace to determine overhead hazards were present, necessitating the use of head protection.
Recent events (2)
  • — I (O) $0
  • — Z (O) $0

COPART

COPART

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 348077561.