Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,645Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: MCKENZIE SUPPLY & EQUIPMENT, INC.

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of MCKENZIE SUPPLY & EQUIPMENT, INC. in 1660 20 1/2 ST., RICE LAKE, WI 54868 (NAICS 000000). OSHA activity number 300251709.

Watch Mckenzie Supply & Equipment, INC. — free Get an email when a new federal OSHA severe-injury report for Mckenzie Supply & Equipment, INC. is published. One employer, no account, unsubscribe in one click.
Site address
1660 20 1/2 ST.
City
RICE LAKE
State
WI
ZIP
54868
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
N
Opened
Closing conference
Case closed
Data loaded
NAICS code
000000
SIC code (legacy)
3531
Employees
9
Ownership type
A

6 citations on file for this inspection.

5(a)(1)

Serious Gravity 02 2 instances 4 exposed
Issued
Abate by
Penalty
Initial $600.00 · Current $300.00 Reduced
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing or likely to cause death or serious physical harm to
employees in that employees
were exposed to: Being struck by the load should the jib monorail
assemblies or underhung chain
hoists fail:
(a)  In the manufacturing building; four jib type monorails with attached
underhung chain hoists
are supported from two steel and concrete filled posts ( two monorails per
post).  These
monorail and post assemblies which were fabricated in house and carry no
labeling of load
rating, it was unknown what loads these assemblies could carry thus posing
a crushing hazard
to employees if they were to fail.
(b)  In the manufacturing, repair, and paint buildings; underhung
electrical and hand operated
chain hoists such as but not limited to two Wrightway 2000 pound, one CM
1/2
Ton, and one
Lodestar chain hoist, no complete program of frequent or periodic
inspections has been
implemented.
Among other methods, feasible and acceptable methods to correct these
hazards are:
(a)  Determine the load rating of the two jib monorail and post
assemblies, ensuring that
they are at least equal to the rating of the maximum capacity of the
underhung hoists, or
provide a structure with such rating, as per ANSI B30.16-1.3.2.
(b)  Perform frequent inspections at daily to monthly intervals and
periodic inspections
at monthly to yearly intervals as per ANSI B30.16-2.1, 2.1.2., 2.1.3., or
the owners
manuals for all overhead hoists in your facility.  Written, dated and
signed inspection
reports should be maintained at time intervals specified in ANSI
B30.16-2.1.1(b)(2).
Recent events (2)
  • — I (S) $300.00
  • — Z (S) $600.00

1910.147 C01

Serious Gravity 03 1 instance 3 exposed
Issued
Abate by
Penalty
Initial $750.00 · Current $375.00 Reduced
Recent events (2)
  • — I (S) $375.00
  • — Z (S) $750.00

1910.1200 E01

Serious Gravity 01 1 instance 2 exposed
Issued
Abate by
Penalty
Initial $450.00 · Current $225.00 Reduced
Recent events (2)
  • — I (S) $225.00
  • — Z (S) $450.00

1910.134 C01

Other-than-serious Gravity 01 1 instance 1 exposed
Issued
Abate by

1910.178 L01 I

Other-than-serious Gravity 01 1 instance 3 exposed
Issued
Abate by

1910.184 E01

Other-than-serious Gravity 01 1 instance 3 exposed
Issued
Abate by

KGC, INC.

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 300251709.