Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,645Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: PIONEER EFS MIDSTREAM, L.L.C.

Accident-driven inspection · Safety discipline

On , OSHA opened an accident-driven safety inspection of PIONEER EFS MIDSTREAM, L.L.C. in CENTRAL GATHERING POINT 71, KENEDY, TX 78119 (NAICS 211112). OSHA activity number 316032176.

Watch Pioneer EFS Midstream, L.L.C. — free Get an email when a new federal OSHA severe-injury report for Pioneer EFS Midstream, L.L.C. is published. One employer, no account, unsubscribe in one click.
Site address
CENTRAL GATHERING POINT 71
City
KENEDY
State
TX
ZIP
78119
Mailing
5205 NORTH O'CONNOR BLVD, SUITE 200, IRVING, TX 75039
Inspection type
Accident-driven (A)
Scope
Partial (B)
Discipline
Safety
Advance notice
Yes
Union status
N
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
211112
SIC code (legacy)
1321
Employees
4
Ownership type
A

1 citation on file for this inspection.

5(a)(1)

Deleted Serious Gravity 05 1 instance 1 exposed
Issued
Abate by
Penalty
Initial $2975.00 · Current $2975.00
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not
furnish employment and a place of employment which were free from
recognized hazards that
were causing, or likely to cause, death or serious physical harm to
employees in that employees
were exposed to a fall hazard:
a.At this jobsite, on the top step of a twenty-five step stairway on the
north
side of slop oil tank number 201 there were three raised hex head bolts
securing the stairway to the elevated walkway.  These raised hex head
bolts created a potential tripping hazard.
b.At this jobsite, the stairway on the north side of Slop Oil Tank number
201, was constructed with angle iron extending from the front of each
stairway step to the next stairway step along each side of the steps of the
twenty-five step stairway.  The angle iron on each side extended beyond
the surface of the tread at the top step of the stairway which created a
potential tripping hazard when an employee descends the stairway.
One feasible and acceptable abatement method for item (a) would be to
replace
the raised hex head bolts with slick head stove bolts where the head would
be
flush with the slip-resistant metal grating.  For item (b) one feasible and
acceptable abatement method would be to remove the end of the angle iron
which
extends above the surface on both sides of the top stair tread.
Recent events (2)
  • — D (S) $2975.00
  • — Z (S) $2975.00

RNWBL

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 316032176.