OSHA Inspection: JEM TOOL & MANUFACTURING COMPANY, INC.

Issued

2012-01-18 00:00:00

Abate by

2012-02-17 00:00:00

Penalty

Initial $2400.00 · Current $1680.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(1):     The employer did not establish a program consisting of an energy control procedure, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative:    Jem Tool & Manufacturing Company did not establish a written lockout program, nor was lockout performed on machinery while performing servicing or maintenance on the machines.    Abatement documentation is required for this item in accordance with 29 CFR 1903.19(d).

Issued

2012-01-18 00:00:00

Abate by

2012-02-17 00:00:00

Penalty

Initial $1800.00 · Current $1260.00 Reduced

General-duty citation text

29 CFR 1910.178(l)(1)(i):     The employer did not ensure that each powered industrial truck operator was competent to operate a powered industrial truck safely, as demonstrated by the successful completion of the training and evaluation specified in this paragraph (l)    Jem Tool & Manufacturing Company did not provide powered industrial truck training for all forklift drivers.    Abatement certification is required for this item in accordance with 29  CFR 1903.19(c).

Issued

2012-01-18 00:00:00

Abate by

2012-02-17 00:00:00

Penalty

Initial $1800.00 · Current $1260.00 Reduced

General-duty citation text

29 CFR 1910.212(a)(1):     One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created by point of operation, ingoing nip points, rotating parts, flying chips and sparks:    The following lathes were not provided with chuck/chip guards:        a. LeBlond Lathe      b. Clausing-Colchester Lathe      c. South Bend Lathe      d. Victor Lathe    Abatement documentation is required for this item in accordance with 29 CFR 1903.19(d).

Issued

2012-01-18 00:00:00

Abate by

2012-03-01 00:00:00

Penalty

Initial $2400.00 · Current $1680.00 Reduced

General-duty citation text

29 CFR 1910.213(d)(1):     Circular handfed crosscut table saw(s) were not guarded by an automatically adjusting hood which completely enclosed that portion of the saw above the table and above the material being cut:    The Delta 10" table saw was not equipped with a saw blade guard.    Abatement documentation is required for this item in accordance with 29 CFR 1903.19(d).