OSHA Inspection: DL READY

Issued

2012-06-06 00:00:00

Penalty

Initial $1600.00 · Current $960.00 Reduced

General-duty citation text

29 CFR 1926.451(b)(1):   Each platform on all working levels of scaffolds was not fully planked or decked between the front uprights and the guardrail supports as specified in paragraphs 1926.451(b)(1)(i)-(ii):    At the site, where employees walked on the scaffold platform that was not fully planked to access the scaffold outrigger to perform masonry work.

Issued

2012-06-06 00:00:00

Penalty

Initial $1600.00 · Current $960.00 Reduced

General-duty citation text

29 CFR 1926.451(c)(1):   Supported scaffolds with a height to base width (including outrigger supports, if used) ratio of more than four to one (4:1) were not restrained from tipping by guying, tying, bracing, or equivalent means, as set forth in subparagraphs (i) - (iii) of this paragraph:    At the site, where an employee was working from a scaffold that was four tiers in height and was not tied back to the building.  This condition exposed the employee to a fall hazard.

Issued

2012-06-06 00:00:00

Penalty

Initial $2400.00 · Current $1440.00 Reduced

General-duty citation text

29 CFR 1926.451(e)(1):   When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, sturcure, personnel hoist, or similar surface was not used.  Crossbraces were used as a means of access:    At the site, where employees were working from a scaffold that was not equipped with a ladder.  This condition exposed employees to a fall hazard.