OSHA Inspection: NEW WAY PAINTING CORP.

Issued

2013-06-12 00:00:00

Abate by

2013-06-18 00:00:00

Penalty

Initial $2000.00 · Current $2000.00

General-duty citation text

29 CFR 1926.451(e)(1): When scaffold platforms were more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from other scaffold, sturcure, personnel hoist, or similar surface was not used.  Crossbraces were used as a means of access.  (a)  At the worksite - An employee working from a tubular welded scaffold ten feet eleven inches above the ground did not have a safe means to access the working level; on or about 01/30/13.   NOTE:  THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM IN THE ACCORDANCE WITH 29 CFR 1903.19

Issued

2013-06-12 00:00:00

Abate by

2013-06-18 00:00:00

Penalty

Initial $2000.00 · Current $2000.00

General-duty citation text

29 CFR 1926.451(g)(1)(vii): Each employee on a scaffold, not otherwise specified in paragraphs (g)(1)(i) through (g)(1)(vi) of this section, more than 10 feet (3.1 m) above lower level was not protected from falls by the use of personal fall arrest systems or guardrail systems meeting the requirements of paragraph (g)(4) of this section.  (a)  At the worksite - An employee working at ten feet eleven inches above the ground on a tubular welded scaffold was not protected from falling; on or about 01/30/13.  NOTE:  THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM IN THE ACCORDANCE WITH 29 CFR 1903.19

Issued

2013-06-12 00:00:00

Abate by

2013-07-09 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.454(a): The employer did not have each employee who performed work while on a scaffold trained by a person qualified in the subject matter to recognize the hazards associated with the type of scaffold being used and to understand the procedures to control or minimize those hazards.  (a) At the worksite - An employee working from a tubular welded scaffold fell from a height of ten feet eleven inches.  No fall protection was provided; on or about 10/30/13.  NOTE:  THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM IN THE ACCORDANCE WITH 29 CFR 1903.19