OSHA Inspection: DKK INC.

Issued

2013-04-05 00:00:00

Abate by

2013-04-15 00:00:00

Penalty

Initial $1785.00 · Current $1785.00

General-duty citation text

29 CFR 1926.403(b)(2): Listed, labeled, or certified equipment was not installed and used in accordance with instructions included in the listing, labeling, or certification:  (a) Inside the building under renovation on or about February 11, 2013, a 4 inch square electrical box was not used as designed to be used as it laid on the floor instead of being mounted on a surface.  The box was used to power 220 VAC portable power tools.  (b)  Inside the building under renovation on or about February 11, 2013, a 2 inch by 4 inch handy box was not used as designed to be used as it was hung by wires from an electrical panel that powered a 110 VAC outlet in the box.  The box was designed to be mounted on a surface.

Issued

2013-04-05 00:00:00

Abate by

2013-04-15 00:00:00

Penalty

Initial $1785.00 · Current $1785.00

General-duty citation text

29 CFR 1926.403(i)(2)(i): Except as required or permitted elsewhere in this subpart, live parts of electric equipment operating at 50 volts or more was not guarded against accidental contact by cabinets or other forms of enclosures, or by any of the following means:  (a)  Inside the building under renovation on or about February 11, 2013, live buss bars and circuit-breaker terminals were exposed to contact in a 220 VAC electrical panel box.  The box was 12 inches wide by 16 inches high, and the bottom was 45 inches from the floor.  Employees carried rebar and metal posts for concrete shoring in the area.

Issued

2013-04-05 00:00:00

Abate by

2013-04-15 00:00:00

Penalty

Initial $1785.00 · Current $1785.00

General-duty citation text

29 CFR 1926.405(j)(2)(i): Receptacles, cord connectors, and attachment plugs were not constructed so that no receptacle or cord connector will accept an attachment plug with a different voltage or current rating than that for which the device is intended:  (a) Inside the building under renovation on or about February 11, 2013, outlets rated at a 110 VAC were used to supply 220 VAC to a Dae-Kwong DA/B-25 rebar bender.