OSHA Inspection: MEDICAL COMPONENT SPECIALISTS INCORPORATED

Issued

2013-08-27 00:00:00

Abate by

2014-03-31 00:00:00

Penalty

Initial $2000.00 · Current $1000.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(1): The employer did not establish a program consisting of an energy control procedure, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative:    Worksite:            The employer did not develop a written lockout tagout program with machine specific lockout tagout procedures.

Issued

2013-08-27 00:00:00

Abate by

2013-10-17 00:00:00

Penalty

Initial $1600.00 · Current $800.00 Reduced

General-duty citation text

29 CFR 1910.219(d)(1): Pulley(s) with part(s) seven feet or less from the floor or work platform were not guarded in accordance with the requirements specified in 29 CFR 1910.219(m) and (o):    Shop:    1)       The pulley and belt drive of the red wheel transmission drive of the #2 Cincinnati Milling Machine was not enclosed by a guard.     2)        The Pulley and belt drive at the back side of the Van Norman Centerless Grinder was not guarded.     3)        The #0 Cincinnati grinder was not guarded.