OSHA Inspection: KRB PRINTING

Issued

2014-02-11 00:00:00

Abate by

2014-03-10 00:00:00

Penalty

Initial $1600.00 · Current $800.00 Reduced

General-duty citation text

29 CFR 1910.23(c)(1): Open-sided floors and/or platforms four feet or more above adjacent floor or ground level were not guarded with standard railings (or equivalent) and toeboards:Note:  Toeboards are only required when persons can pass, there is moving equipment or there is equipment with which falling materials could create a hazard.     a) Small press area above the paper drilling machine: A storage area used to store cardboard boxes, approximately nine feet above the ground below was not guarded along the open edges by a standard railing or its equivalent, on or about 12/19/13.       NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.

Issued

2014-02-11 00:00:00

Abate by

2014-03-25 00:00:00

Penalty

Initial $1600.00 · Current $800.00 Reduced

General-duty citation text

29 CFR 1910.147(c)(1): The employer did not establish a program consisting of an energy control procedure, employee training and periodic inspections to ensure that before any employee performed any servicing or maintenance on a machine or equipment where the unexpected energizing, startup or release of stored energy could occur and cause injury, the machine or equipment shall be isolated from the energy source and rendered inoperative:     a) Throughout facility: A lockout tagout program was not developed and instituted for equipment serviced or setup by employees, such as, but not limited to Ryobi 3302M two color print press (2), Oliver 472 ed-II four color print press and Challenge Paper Drilling Machine style 4910 number 25941, on or about 12/19/13.      NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.

Issued

2014-02-11 00:00:00

Abate by

2014-03-10 00:00:00

Penalty

Initial $1600.00 · Current $800.00 Reduced

General-duty citation text

29 CFR 1910.212(a)(1): One or more methods of machine guarding was not provided to protect the operator and other employees in the machine area from hazards such as those created by point of operation, ingoing nip points, rotating parts, flying chips and sparks:    a) Large press room: A fan used for cooling purposes did not have a guard covering the blades, on or about 12/19/13.     NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.

Issued

2014-02-11 00:00:00

Abate by

2014-03-10 00:00:00

Penalty

Initial $1600.00 · Current $800.00 Reduced

General-duty citation text

29 CFR 1910.219(d)(1): Pulley(s) with part(s) seven feet or less from the floor or work platform were not guarded in accordance with the requirements specified in 29 CFR 1910.219(m) and (o):     a) Large press room: A pulley operating at 1725 RPM on an Interlake Incorporated stapling machine was not guarded, on or about 12/19/13.     NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.

Issued

2014-02-11 00:00:00

Abate by

2014-03-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.219(e)(1)(i): Horizontal belts which had both runs 42 inches or less from the floor level were not fully enclosed by guards conforming to requirements specified in 29 CFR 1910.219(m) and (o):  a) Large press room: A belt operating at 1725 RPM on an Interlake Incorporated stapling machine was not guarded, on or about 12/19/13.   NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.

Issued

2014-02-11 00:00:00

Abate by

2014-03-10 00:00:00

Penalty

Initial $1200.00 · Current $600.00 Reduced

General-duty citation text

29 CFR 1910.305(b)(2)(i): Each outlet box in completed installations did not have a cover, faceplate, or fixture canopy:    a) Small press room: An outlet box on a Challenge Paper Drilling machine style 4810 number 29541 did not have a cover, on or about 12/19/13.    NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.

Issued

2014-02-11 00:00:00

Abate by

2014-03-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(g)(1)(iv)(B): Flexible cords and/or cables were run through holes in walls, ceilings, or floors:    a) Graphic art/computer design room: An extension cord was run through the ceiling and connected to a power strip that powered computer parts, on or about 12/19/13.    NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.

Issued

2014-02-11 00:00:00

Abate by

2014-03-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(g)(2)(iii): Flexible cords were not connected to devices and fittings so that tension would not be transmitted to joints or terminal screws:   a) Small print area: The cord that connected to and provided power to the second part of the folding machine had a torn strain relief, on or about 12/19/13.    NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.

Issued

2014-02-11 00:00:00

Abate by

2014-03-25 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.1200(e)(1): The employer did not develop, implement, and/or maintain at the workplace a written hazard communication program which described how the criteria specified in 29 CFR 1910.1200(f), (g), and (h) would be met:    a) Throughout facility: The employer did not develop and implement a written hazard communication program for chemicals used by employees  in the workplace, such as, but not limited to, A-60 Odorless 7119, Prisco MRC-F, Allied PC 93, Burnishine Plate Savor, Printers Pride Burnishie 3462Q and Zipset inks, on or about 12/19/13.    NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.

Issued

2014-02-11 00:00:00

Abate by

2014-03-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.1200(f)(6)(ii): Except as provided in 29 CFR 1910.1200(f)(7) and 29 CFR 1910.1200(f)(8), the employer did not ensure that each container of hazardous chemicals in the workplace was labeled, tagged or marked with the product identifier and words, pictures, symbols, or combination thereof, which provide at least general information regarding the hazards of the chemicals and which, in conjunction with the other information immediately available to employees under the hazard communication program, would provide employees with the specific information regarding the physical and health hazards of the hazardous chemicals:  a) Throughout facility: Transfer bottles containing chemicals such as, but not limited to, Prisco MRC-F and A-60 Odorless 7119, were not labeled according to the standard, on or about 12/19/13.   NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.

Issued

2014-02-11 00:00:00

Abate by

2014-03-10 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.1200(h)(1): Employees were not provided effective information and training on hazardous chemicals in their work area at the time of their initial assignment and whenever a new hazard that the employees had not been previously trained about was introduced into their work area:  a) Throughout facility: The employer did not provide effective information and training to employees on hazardous chemicals used in the workplace, such as, but not limited to, A-60 Odorless 7119, Prisco MRC-F, Allied PC 93, Burnishine Plate Savor, Printers Pride Burnishie 3462Q and Zipset inks, on or about 12/19/13.   NOTE: THE EMPLOYER IS REQUIRED TO SUBMIT ABATEMENT CERTIFICATION FOR THIS ITEM. FAILURE TO COMPLY WILL RESULT IN AN ADDITIONAL PENALTY OF $1000.00 IN ACCORDANCE WITH 29 CFR 1903.19.