OSHA Inspection: ZANDER P. LEE GENERAL CONTRACTOR

Issued

2014-04-02 00:00:00

Abate by

2014-04-28 00:00:00

Penalty

Initial $2800.00 · Current $1960.00 Reduced

General-duty citation text

29 CFR 1926.451(e)(1): When scaffold platforms are more than 2 feet (0.6 m) above or below a point of access, portable ladders, hook-on ladders, attachable ladders, stair towers (scaffold stairways/towers), stairway-type ladders (such as ladder stands), ramps, walkways, integral prefabricated scaffold access, or direct access from another scaffold, structure, personnel hoist, or similar surface shall be used. Crossbraces shall not be used as a means of access.    Jobsite:    Employees not using ladders to access or egress work locations on scaffolding.

Issued

2014-04-02 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.451(g)(1): Each employee on a scaffold more than 10 feet (3.1 m) above a lower level shall be protected from falling to that lower level. Paragraphs (g)(1)(i) through (vii) of this section establish the types of fall protection to be provided to the employees on each type of scaffold. Paragraph (g)(2) of this section addresses fall protection for scaffold erectors and dismantlers.  Jobsite:  Employees were exposed to falls while working on scaffolding at heights of 24 feet while throwing job material off the second floor scaffold.

Issued

2014-04-02 00:00:00

Abate by

2014-04-21 00:00:00

Penalty

Initial $1600.00 · Current $1120.00 Reduced

General-duty citation text

29 CFR 1926.451(g)(4)(iv): When midrails are used, they shall be installed at a height approximately midway between the top edge of the guardrail system and the platform surface.    Jobsite:    Missing mid-rails on scaffolding exposing employees to falls greater than 10 feet.

Issued

2014-04-02 00:00:00

Penalty

Initial $1600.00 · Current $1120.00 Reduced

General-duty citation text

29 CFR 1926.451(h)(1): In addition to wearing hardhats each employee on a scaffold shall be provided with additional protection from falling hand tools, debris, and other small objects through the installation of toeboards, screens, or guardrail systems, or through the erection of debris nets, catch platforms, or canopy structures that contain or deflect the falling objects. When the falling objects are too large, heavy or massive to be contained or deflected by any of the above-listed measures, the employer shall place such potential falling objects away from the edge of the surface from which they could fall and shall secure those materials as necessary to prevent their falling.    Jobsite:    Employees exposed to falling objects for not wearing hard hats while working on scaffolding.