OSHA Inspection: SHEA ENTERPRISES, INC.

Issued

2016-01-21 00:00:00

Abate by

2016-02-17 00:00:00

Penalty

Initial $3500.00 · Current $3500.00

General-duty citation text

29 CFR 1926.502(d)(6)(i): Unless the snap hook is a locking type and designed for the following connections, snap hooks shall not be engaged directly to webbing, rope or wire rope.    a) Connected to HVAC Left Side - An employee was exposed to a fall hazard from securing the snap hook to the safety line that was not designed to hook to a safety line, on or about September 8th, 2015.    b) Connected to HVAC Middle - An employee was exposed to a fall hazard from securing the snap hook to the safety line that was not designed to hook to a safety line, on or about September 8th, 2015.    Abatement certification and documentation required within 10 days after abatement date. The certification shall include a statement that abatement is complete, the date and method of abatement, and state that employees and their representatives were informed of this abatement. Abatement documentation shall include documents demonstrating that abatement is complete, such as evidence of the purchase or repair of equipment, photographic or video evidence of abatement or other written records.

Issued

2016-01-21 00:00:00

Abate by

2016-02-17 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.502(d)(16)(iii): Personal fall arrest systems, when stopping a fall, were not rigged such that an employee could not free fall more than 6 feet (1.8 m) nor contact any lower level:  a) Connected to HVAC Left Side - An employee was exposed to a fall hazard of approximately fifteen (15) feet from slack in lanyard used in the personal fall arrest system, on or about September 8th, 2015.  Abatement certification and documentation required within 10 days after abatement date. The certification shall include a statement that abatement is complete, the date and method of abatement, and state that employees and their representatives were informed of this abatement. Abatement documentation shall include documents demonstrating that abatement is complete, such as evidence of the purchase or repair of equipment, photographic or video evidence of abatement or other written records.

Issued

2016-01-21 00:00:00

Abate by

2016-02-17 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.502(d)(17): The attachment point of the body harness was not located in the center of the wearer's back near shoulder level, or above the wearer's head:  a) Connected to HVAC Middle - An employee installing nailing strips was exposed to a fall hazard from not wearing the attachment point of the body harness near shoulder level, on or about September 8th, 2015.  Abatement certification and documentation required within 10 days after abatement date. The certification shall include a statement that abatement is complete, the date and method of abatement, and state that employees and their representatives were informed of this abatement. Abatement documentation shall include documents demonstrating that abatement is complete, such as evidence of the purchase or repair of equipment, photographic or video evidence of abatement or other written records.

Issued

2016-01-21 00:00:00

Abate by

2016-02-17 00:00:00

Penalty

Initial $3500.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.502(d)(15): Anchorage used for attachment for personal fall arrest equipment was not capable of supporting at least 5,000 pounds (22.2 KN) per employee attached nor was it designed, installed and used as follows:     a) AES Raptor R1000 On Roof - An employee installing nailers on a parapet was exposed to a fall hazard of approximately 15 feet from not properly using the "AES Raptor R1000" as noted in the instruction manual, on or about September 8th 2015.    Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.

Issued

2016-01-21 00:00:00

Abate by

2016-02-17 00:00:00

Penalty

Initial $2100.00 · Current $0.00 Reduced

General-duty citation text

29 CFR 1926.405(g)(2)(iv): Flexible cords were not connected to devices and fittings so that strain relief is provided to prevent pull from being directly transmitted to joints or terminal screws:    a) Roof Edge - Employees installing nailers on the parapet were exposed to an electrical hazard from an extension cord with no strain relief, exposing 3/4 of an inch of wire by the female plug, September 8th, 2015.    Abatement certification required within 10 days after abatement date. The certification shall include a statement that abatement is complete, date and method of abatement, and states employees and their representatives were informed of this abatement.