Safety Incidents OSHA Severe Injury Reports · 2015–2025
2,004,209Inspections Most recent open 2026-07-13 Last loaded 2026-07-17

OSHA Inspection: BERGERON FRAMING, INC.

Unprogrammed Other inspection · Safety discipline

On , OSHA opened an unprogrammed Other safety inspection of BERGERON FRAMING, INC. in 10601 GANDY BOULEVARD NORTH, SAINT PETERSBURG, FL 33702 (NAICS 238130). OSHA activity number 341374098.

Watch Bergeron Framing, INC. — free Get an email when a new federal OSHA severe-injury report for Bergeron Framing, INC. is published. One employer, no account, unsubscribe in one click.
Site address
10601 GANDY BOULEVARD NORTH
City
SAINT PETERSBURG
State
FL
ZIP
33702
Mailing
125 BAYWOOD AVENUE, LONGWOOD, FL 32750
Inspection type
Unprogrammed Other (I)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
8
Ownership type
A

3 citations on file for this inspection.

1903.19 D01

Other-than-serious 2 instances 2 exposed
Issued
Abate by
Penalty
Initial $1000.00 · Current $1000.00
29 CFR 1903.19(d)(1): The employer did not submit to the Agency documents demonstrating that abatement is complete for each willful or repeat violation and for any serious violation for which the Agency indicates in the citation that such abatement documentation is required.  On or about July 6, 2016, for the inspection site on 10601 Gandy Boulevard North in Saint Petersburg, FL:  a) Abatement documentation was not provided for citation 1 item 1a, and  b) Abatement documentaion was not provided for citaion 1 item 1b.
Recent events (1)
  • — Z (O) $1000

1926.501 B13

Other-than-serious 2 instances 8 exposed
Issued
Abate by
Penalty
Initial $2800.00 · Current $2800.00
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m)  or more above lower levels was not protected by guardrail systems, safety net systems, personal fall arrest systems, or an alternative fall protection measure under another provision of paragraph 1926.501 (b), nor did the employer demonstrate that it is infeasible or creates a greater hazard to use these systems and develop and implement a fall protection plan which meets the requirements of paragraph (k) of section 1926.502:       (a) At the job site, employees erecting wood trusses exposed to a fall hazard of approximately 40 feet. Feasible conventional fall protection methods such as but no limited to scissor lifts or booms, bracket scaffolding attached to the inside or outside of the exterior walls, spreader bars attached to roof trusses, work practices (completing truss sections, erecting and sheeting a series of trusses on the ground and then lifting the unit into place with a crane) to minimize the risk of falls while employees were erecting wood trusses and exposed to fall hazard of approximately 40 feet on or about were not provided as observed on or about 01/21/2016.
Recent events (2)
  • — I (O) $2800
  • — Z (S) $2800

1926.502 K06

Other-than-serious 1 instance 8 exposed
Issued
Abate by
Penalty
Initial $0.00 · Current $0.00
29 CFR 1926.502(k)(6): The fall protection plan did not include a written discussion of other measures that will be taken to reduce or eliminate the fall hazard for workers who cannot be provided with protection from the conventional fall protection systems. For example, the employer did not discuss the extent to which scaffolds, ladders, or vehicle mounted work platforms can be used to provide a safer working surface and thereby reduce the hazard of falling.    a) At the job site, the fall protection plan did not consider other alternative fall protection systems criteria and practices such as but not limited to the use scissor lifts or booms, bracket scaffolding attached to the inside or outside of the exterior walls, spreader bars attached to roof trusses, work practices (completing truss sections, erecting and sheeting a series of trusses on the ground and then lifting the unit into place with a crane) to minimize the risk of falls while employees were erecting wood trusses and exposed to fall hazard of approximately 40 feet, on or about 01/21/2016.
Recent events (2)
  • — I (O) $0
  • — Z (S) $0

View BERGERON FRAMING, INC.'s full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 341374098.