OSHA Inspection: ENITOR ENTERPRISES

Issued

2018-03-16 00:00:00

Abate by

2018-04-13 00:00:00

Penalty

Initial $2956.00 · Current $1600.00 Reduced

General-duty citation text

OSH ACT of 1970 Section (5)(a)(1): The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to crushing, struck-by and electrical hazards while using automotive lifts:    (a)  On or about February 22, 2018, and at times prior the employer did not ensure that employees         were safe from crushing,  struck-by and electrical hazards due to the following:        (1)  Bend-Pak hydraulic lift power unit, located in bay three, was modified with an electrical switch which was not in       accordance with the manufacturers requirements for safe operation.                  (2) Auto lifts were not periodically inspected by a qualified inspector at least annually to ensure that they were       properly maintained and functioning in a safe manner.    Abatement Note: Abatement certification and documentation are required for this item (see enclosed "Certification of Corrective Action Worksheet").

Issued

2018-03-16 00:00:00

Abate by

2018-04-13 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.303(b)(2): Listed or labeled electrical equipment was not used or installed in accordance with instructions included in the listing or labeling.     (a)  On or about February 22, 2018, and times prior, employees were exposed to electrical injuries in that an electrical switch was installed on the Bend-Pak hydraulic lift power unit, model number AB-1380, located in bay three, and was not used in in accordance with its listing or labeling.      Abatement Note:  Abatement certification and documentation are required for this item (see enclosed "Certification of Corrective Action Worksheet").

Issued

2018-03-16 00:00:00

Abate by

2018-04-13 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1910.305(b)(1)(i): Conductors entering cutout boxes, cabinets, or fittings were not protected from abrasions:    (a) On or about February 22, 2018, and at times prior, employees were exposed to shock and fire hazards where the power cords entering the motor housing of the Bend-Pak lift power unit, model number AB-1380, were not protected from damage and/or abrasions at the cutout.      Abatement Note:  Abatement certification and documentation are required for this item (see enclosed "Certification of Corrective Action Worksheet").