OSHA Inspection: FRAME & FINISH CARPENTERS, INC.

Issued

2018-08-14 00:00:00

Abate by

2018-09-17 00:00:00

Penalty

Initial $311.00 · Current $311.00

General-duty citation text

29 CFR 1903.19(c)(1): The employer did not certify to OSHA, within 10 calendar days after the abatement date, that the cited violation had been abated:       Frame & Finish Carpenters, Inc. failed to certify to OSHA within 10 calendar days after the abatement date that each of the following cited violations had been corrected:       Citation Number         Item Number                 Abatement Date   01                            01                                05/25/2018   01                            03a                              05/25/2018   01                            03b                              05/25/2018   01                            03c                              05/25/2018   01                            04a                              05/25/2018   01                            04b                              05/25/2018     In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF THE CORRECTIVE ACTION WORKSHEET).

Issued

2018-05-21 00:00:00

Abate by

2018-05-25 00:00:00

Penalty

Initial $2217.00 · Current $2217.00

General-duty citation text

29 CFR 1926.102(a)(1): Employees were not provided with eye and face protection when machines or operations present potential eye or face injury from physical, chemical, or radiation agents:               a) On or about April 24, 2018, employees were exposed to eye injury while operating nail guns without the benefit of eye protection.              In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).

Issued

2018-05-21 00:00:00

Penalty

Initial $3880.00 · Current $3880.00

General-duty citation text

29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501(b):            a) On or about May 24, 2018, employees were exposed to the hazard of falling approximately 17 feet to the exterior of the building while performing carpentry work from the top of exterior walls.   b) On or about May 24, 2018, employees were exposed to the hazard of falling approximately 27 feet to the exterior of the building while performing carpentry work from the edges of upper level floors.     No abatement certification or documentation required for this violation.

Issued

2018-05-21 00:00:00

Abate by

2018-05-25 00:00:00

Penalty

Initial $3326.00 · Current $3326.00

General-duty citation text

29 CFR 1926.1052(c)(1)(i): Stairways having four or more risers or rising more than 30 inches (76 cm), whichever is less, were not equipped with at least one handrail:      a) On or about April 24, 2018, stairways between the first level of the building and the upper work levels where carpentry work was being conducted were not equipped with at least on handrail.       In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).

Issued

2018-05-21 00:00:00

Abate by

2018-05-25 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.1052(c)(1)(ii): Stairways having four or more risers or rising more than 30 inches (76 cm), whichever is less, were not equipped with a stairrail system along each unprotected side or edge:        a) On or about April 24, 2018, stairways between the first level of the building and upper work levels where carpentry work was being conducted were not equipped with stairrail systems along unprotected sides or edges.        In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).

Issued

2018-05-21 00:00:00

Abate by

2018-05-25 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.1052(c)(12): Unprotected sides and edges of stairway landings were not provided with guardrail systems that meet the criteria contained in Subpart M of 29 CFR 1926;     a) On or about April 24, 2018, a stairway landing between the main level of the building and an upper level was as not equipped with a guardrail system along its unprotected sides or edges.     In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).

Issued

2018-05-21 00:00:00

Abate by

2018-05-25 00:00:00

Penalty

Initial $3326.00 · Current $3326.00

General-duty citation text

29 CFR 1926.1053(a)(1)(ii): Job-made ladder were not built in conformance with applicable provisions of Appendix A:     a) On or about April 24, 2018, the cleats/rungs of a job-made ladder provided for employee use to enter and exit the building were not joined/spliced to the ladder rails as prescribed by American National Standards Institute (ANSI) A14.4-1992 - Safety Requirements for Job-Made Ladders.     In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).

Issued

2018-05-21 00:00:00

Abate by

2018-05-25 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.1053(b)(1): Portable ladders were used for access to an upper landing surface and the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface to which the ladder was used to gain access:     a) On or about April 24, 2018, a portable job-made ladder used to enter and exit the building did not extend above the landing surface at an elevation of about 7 feet.     In accordance with 29 CFR 1903.19(c), abatement certification is required for this violation (using the CERTIFICATION OF CORRECTIVE ACTION WORKSHEET).