Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,189,645Inspections Most recent open 2026-07-16 Last loaded 2026-07-20

OSHA Inspection: GV FRAMING & REMODELING, LLC

Referral inspection · Safety discipline

On , OSHA opened a referral safety inspection of GV FRAMING & REMODELING, LLC in (LOT #90) 640 HANLON WAY, ALPHARETTA, GA 30009 (NAICS 238130). OSHA activity number 343502886.

Watch GV Framing & Remodeling, LLC — free Get an email when a new federal OSHA severe-injury report for GV Framing & Remodeling, LLC is published. One employer, no account, unsubscribe in one click.
Site address
(LOT #90) 640 HANLON WAY
City
ALPHARETTA
State
GA
ZIP
30009
Mailing
1647 DEBBIE DRIVE, MABLETON, GA 30126
Inspection type
Referral (C)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Last modified
Data loaded
NAICS code
238130
Employees
5
Ownership type
A

2 citations on file for this inspection.

1926.501 B13

Serious Gravity 10 1 instance 3 exposed
Issued
Penalty
Initial $3880.00 · Current $3880.00
29 CFR 1926.501(b)(13): Each employee engaged in residential construction activities 6 feet (1.8 m)  or more above lower levels was not protected by guardrail systems, safety net systems, personal fall arrest systems, or an alternative fall protection measure under another provision of paragraph 1926.501 (b), nor did the employer demonstrate that it is infeasible or creates a greater hazard to use these systems and develop and implement a fall protection plan which meets the requirements of paragraph (k) of section 1926.502:   (a) New residential construction located on Lot #90, Third floor: On or about 10/01/2018, and at times prior, the employer exposed employees to fall hazards of 23-feet, 1-inch to the lower level, in that a fall protection system was not provided to employees engaged in framing activities.
Recent events (1)
  • — Z (S) $3880

1926.1053 B01

Serious Gravity 5 1 instance 4 exposed
Issued
Penalty
Initial $2217.00 · Current $2217.00
29 CFR 1926.1053(b)(1): Where portable ladders were used for access to an upper landing surface and the ladder's length allows, the ladder side rails did not extend at least 3 feet (.9 m) above the upper landing surface being accessed:  (a) New residential construction located on Lot #90, First floor: On or about 10/01/2018, and at times prior, the employer exposed employees to fall hazards of approximately 10-feet, 6-feet to the lower level, in that safe access to the second level landing was not provided as the ladder used was only extended 4-inches past the landing and not 3-feet to allow for safe access to the upper and lower levels.
Recent events (1)
  • — Z (S) $2217

View GV FRAMING & REMODELING, LLC's full OSHA safety record →

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 343502886.