OSHA Inspection: PRECISION CUT CARPENTRY, LLC

Issued

2020-05-04 00:00:00

Abate by

2020-05-13 00:00:00

Penalty

Initial $29686.00 · Current $29686.00

General-duty citation text

29 CFR 1926.501(b)(13): Each employee(s) engaged in residential construction activities 6 feet (1.8 m) or more above lower levels were not protected by guardrail systems, safety net system, or personal fall arrest system, nor were employee(s) provided with an alternative fall protection measure under another provision of paragraph 1926.501.  a)     Precision Cut Carpentry LLC. on or about February 11, 2020, at the site location of 8625 Brint Rd Lot 39 (5020), Sylvania, Ohio: The employer did not ensure employees were protected from falls while installing framing atop a second level of a residential type new construction structure. Two employees were exposed to falls of a roughly 18 to the level below while performing framing activities. No form of fall protection was in place.

Issued

2020-05-04 00:00:00

Abate by

2020-05-13 00:00:00

Penalty

Initial $8906.00 · Current $8906.00

General-duty citation text

29 CFR 1926.20(b)(1): The employer did not initiate and maintain such programs as may be necessary to comply with this part.    a) Precision Cut Carpentry LLC. on or about February 11, 2020, at the site location of 8625 Brint Rd Lot 39 (5020), Sylvania, Ohio: The employer did not have a plan or program to identify job site hazards which assists employees in maintaining a safe working environment. Such programs would support the employer and employees in identifying and avoiding potential hazards such as, but not limited to, falls during job site operations. Two employees were exposed to falls of a roughly 18 to the level below while performing framing activities. No form of fall protection was in place.    Precision Cut Carpentry LLC., was previously cited for a violation of this Occupational Safety and Health Standard (29 CFR 1926. 20(b)(1)), which was contained in OSHA inspection #1219150, Citation number 3, Item number 1b, and  was affirmed as final order on 07/17/2017, with respect to a workplace located at 7604 Shoemaker Drive, Waterville, OH 43566.

Issued

2020-05-04 00:00:00

Abate by

2020-05-13 00:00:00

Penalty

Initial $0.00 · Current $0.00

General-duty citation text

29 CFR 1926.503(a)(1): The employer did not provide a training program for each employee potentially exposed to fall hazards to enable each employee to recognize the hazards of falling and the procedures to be followed in order to minimize these hazards.  a)     Precision Cut Carpentry LLC. on or about February 11, 2020, at the site location of 8625 Brint Rd Lot 39 (5020), Sylvania, Ohio: Two employees were observed conducting framing activities while working near a roof edge atop the second level of a new residential construction structure. The employer did not ensure that a fall protection training program was in place for employees that were exposed to fall hazards over six feet in residential construction. Two employees were exposed to falls of roughly 18 to the level below while performing framing activities. No form of fall protection was in place.   Precision Cut Carpentry LLC., was previously cited for a violation of this Occupational Safety and Health Standard (29 CFR 1926. 503(a)(1)), which was contained in OSHA inspection #1219150, Citation number 1, Item number 1b, and was affirmed as final order on 07/17/2017, with respect to a workplace located at 7604 Shoemaker Drive, Waterville, OH 43566.