DELAWARE, OH —
OSHA Inspection: ERLIN THE FRAMER, LLC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of ERLIN THE FRAMER, LLC. in 326 LENELL LOOP - BUILDING 44, DELAWARE, OH 43015 (NAICS 238130). OSHA activity number 345693469.
Where did this inspection happen?
- Establishment
- ERLIN THE FRAMER, LLC.
- Site address
- 326 LENELL LOOP - BUILDING 44
- City
- DELAWARE
- State
- OH
- ZIP
- 43015
- Mailing
- 3599 QUICKWATER ROAD, GROVE CITY, OH 43123
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 238130
- Employees
- 5
- Ownership type
- A
Citations
6 citations on file for this inspection.
1926.102 A01
- Issued
- Penalty
- Initial $3218.00 · Current $1287.00 Reduced
General-duty citation text
29 CFR 1926.102(a)(1): The employer shall ensure that each affected employee uses appropriate eye or face protection when exposed to eye or face hazards from flying particles, molten metal, liquid chemicals, acids or caustic liquids, chemical gases or vapors, or potentially injurious light radiation. a. Located at 326 Lenell Loop - Building 44, Delaware, Ohio: On or about December 15, 2021, and at times prior, an employee was operating a portable circular saw to cut plywood without utilizing eye protection, thereby exposing the employee to struck-by hazards. b. Located at 326 Lenell Loop - Building 44, Delaware, Ohio: On or about December 15, 2021, and at times prior, an employee was operating a pneumatic nail gun to perform framing work without utilizing eye protection, thereby exposing the employee to struck-by hazards.
Recent events (2)
- — I (S) $1287.2
- — Z (S) $3218
1926.300 A
- Issued
- Abate by
- Penalty
- Initial $2575.00 · Current $1030.00 Reduced
General-duty citation text
29 CFR 1926.300(a): Condition of tools. All hand and power tools and similar equipment, whether furnished by the employer or the employee, shall be maintained in a safe condition. a. Located at 326 Lenell Loop - Building 44, Delaware, Ohio: On or about December 15, 2021, employees were utilizing a portable circular saw with a damaged electrical cord, thereby exposing employees to electrical shock hazards.
Recent events (2)
- — I (S) $1030
- — Z (S) $2575
1926.405 G02 IV
- Issued
- Abate by
- Penalty
- Initial $2575.00 · Current $1030.00 Reduced
General-duty citation text
29 CFR 1926.405(g)(2)(iv): Strain relief. Flexible cords shall be connected to devices and fittings so that strain relief is provided which will prevent pull from being directly transmitted to joints or terminal screws. a. Located at 326 Lenell Loop - Building 44, Delaware, Ohio: On or about December 15, 2021, an employee was operating a portable circular saw that was plugged into an extension cord that did not have adequate strain relief. As a result, the inner components of the extension cord were exposed, thereby exposing employees to electrical shock hazards.
Recent events (2)
- — I (S) $1030
- — Z (S) $2575
1926.502 D16 III
- Issued
- Abate by
- Penalty
- Initial $4505.00 · Current $1802.00 Reduced
General-duty citation text
29 CFR 1926.502(d)(16): Personal fall arrest systems, when stopping a fall, shall: 29 CFR 1926.502(d)(16)(iii): be rigged such that an employee can neither free fall more than 6 feet (1.8 m), nor contact any lower level; a. Located at the job site at 326 Lenell Loop - Building 44, Delaware, Ohio: On or about December 15, 2021, an employee was observed working from the roof of a new-build residential structure performing framing work with a personal fall arrest system that was not rigged to prevent the employee from contacting the lower level. As a result, the employee was exposed to falls from a height of approximately 10 feet.
Recent events (2)
- — I (S) $1802
- — Z (S) $4505
1926.1053 B01
- Issued
- Penalty
- Initial $3218.00 · Current $1287.00 Reduced
General-duty citation text
29 CFR 1926.1053(b)(1): When portable ladders are used for access to an upper landing surface, the ladder side rails shall extend at least 3 feet (.9 m) above the upper landing surface to which the ladder is used to gain access; or, when such an extension is not possible because of the ladder's length, then the ladder shall be secured at its top to a rigid support that will not deflect, and a grasping device, such as a grabrail, shall be provided to assist employees in mounting and dismounting the ladder. In no case shall the extension be such that ladder deflection under a load would, by itself, cause the ladder to slip off its support. a. Located at 326 Lenell Loop - Building 44, Delaware, Ohio: On or about December 15, 2021, an employee was observed utilizing a portable extension ladder to access the roof that was not extended at least 3 feet above the roof, nor did it have a grasping device in place. The employee was thereby exposed to a fall hazard of approximately 10 feet to the ground below.
Recent events (2)
- — I (S) $1287.2
- — Z (S) $3218
1926.501 B13
- Issued
- Abate by
- Penalty
- Initial $9011.00 · Current $3604.00 Reduced
General-duty citation text
29 CFR 1926.501(b)(13):"Residential construction." Each employee engaged in residential construction activities 6 feet (1.8 m) or more above lower levels shall be protected by guardrail systems, safety net system, or personal fall arrest system unless another provision in paragraph (b) of this section provides for an alternative fall protection measure. Exception: When the employer can demonstrate that it is infeasible or creates a greater hazard to use these systems, the employer shall develop and implement a fall protection plan which meets the requirements of paragraph (k) of 1926.502. a. Located at 326 Lenell Loop - Building 44, Delaware, Ohio: On or about December 15, 2021, two employees were observed on the roof of the residential structure being built performing framing work without adequate fall protection measures in use. The employees were thereby exposed to falls from heights to the ground below of approximately 10 feet. Erlin the Framer, LLC. was previously cited for a Serious violation of this Occupational Safety and Health Standard, 1926.501(b)(13) which was contained in OSHA inspection number 1456590, citation number 1, item number 1, and was affirmed as a final order on February 5, 2020, with respect to a workplace located at 939 Ravine View Drive, Galena, Ohio.
Recent events (2)
- — I (R) $3604.4
- — Z (R) $9011
More inspections at ERLIN THE FRAMER, LLC.
GALENA, OH—2020-01-17 00:00:00
ERLIN THE FRAMER, LLC.
View ERLIN THE FRAMER, LLC.'s full OSHA safety record →
More inspections in this industry (NAICS 238130)
MOUNT JULIET, TN—2026-07-17 00:00:00
M AND F CONSTRUCTION LLC
MERIDIAN, ID—2026-07-17 00:00:00
CARRILLO CONSTRUCTION LLC
MERIDIAN, ID—2026-07-17 00:00:00
SEVY BROTHERS CONSTRUCTION LLC
WESTFORD, MA—2026-07-17 00:00:00
M&M CONSTRUCTION SERVICES CORP
FAIRHOPE, AL—2026-07-16 00:00:00
FRANCISCO ARIAS
More inspections in OH
DAYTON, OH—2026-07-17 00:00:00
TEKNOL, INC.
PAYNE, OH—2026-07-16 00:00:00
LIPPERT
SUGARCREEK, OH—2026-07-16 00:00:00
PROVIA
CINCINNATI, OH—2026-07-16 00:00:00
GREENACRES FOUNDATION
WELLINGTON, OH—2026-07-16 00:00:00
WHIRLAWAY CORPORATION
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 345693469.