AUSTIN, TEXAS—
CAPFORM, INC.
Struck, caught, or crushed in other collapsing structure or equipment · Fractures and dislocations
Final narrative
Two employees were taking cross-braces off a shoring tower and handing them to a third employee at the base of the frame. They were working from the top down, and had removed the braces from the top two sections; as they began to remove the braces from the bottom section, the tower tipped over and landed on the employee on the ground. The employee suffered three broken vertebrae and three dislocated vertebrae in the back.
Similar incidents · Same event type
SAN ANTONIO, TEXAS—
Williams Brothers Construction Co., Inc
A mixer truck driver was delivering a load of concrete to a jobsite. The driver was operating the controls outside of his truck when a 6x10-foot fascia wall gave way. One of the concrete fascia panels struck the driver's right calf resulting in amputation of the leg below the knee.
NEW BEDFORD, MASSACHUSETTS—
Mohawk Northeast, Inc.
An employee was installing sheet piles when a pier collapsed and they sustained a broken leg.
MIAMI, FLORIDA—
M&B Developing Group, Inc.
An employee was receiving a 32-by-8 panel wall that weighed 3,500 pounds. As the crane was going up, the cable of one of the clanks became caught on the panel wall. The panel wall collapsed and struck the employee's right leg, resulting in right leg fractures and amputation below the knee.
LEWISVILLE, TEXAS—
Ericsson Smart Factory
An employee was moving conveyors in a warehouse to another location using rolling casters. The legs became detached from the bottom of the conveyor, and the employee's right index finger was caught in the conveyor pinch point, resulting in a fingertip amputation.
DURANGO, COLORADO—
Bryan Construction Inc
An employee was participating in demolition work when a non-structural wall collapsed on him. The employee was hospitalized with a fractured shoulder.