REFUGIO, TX ·
OSHA Inspection: J & C DRILLING CO., RIG #10
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of J & C DRILLING CO., RIG #10 in S.W. CORNER OF HWY. 77 & HWY. 239, REFUGIO, TX 78377 (NAICS 000000). OSHA activity number 100654417.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- J & C DRILLING CO., RIG #10
- Site address
- S.W. CORNER OF HWY. 77 & HWY. 239
- City
- REFUGIO
- State
- TX
- ZIP
- 78377
- Mailing
- P.O. BOX 216, REFUGIO, TX 78377
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1381
- Employees
- 13
- Ownership type
- Private (A)
Citations
9 citations on file for this inspection.
5(a)(1)
- Issued
- Jul 13, 1987
- Abate by
- Jul 20, 1987
- Penalty
- Initial $200 · Current $120 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The %% employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: The hazard of collapse/toppling of the meat (derrick) of a well service rig resulting from inadequately installed guyline anchors, in that the pull out integrity was not determined to assure adequate anchorage. This condition existed May 20, 1987, on J & C Drilling Co., Rig #10, at the O'Connor Well #68, 22 miles North of Refugio, Texas, while employees were required to perform work off the rig floor and monkey board. Among other methods, one feasible and acceptable abatement method to correct this hazard is to properly install guyline anchors and ensure pull out integrity for adequate anchorage by conducting pull tests.
Recent events (2)
- · I (S) $120.00
- · Z (S) $200.00
5(a)(1)
- Issued
- Jul 13, 1987
- Abate by
- Jul 17, 1987
- Penalty
- Initial $160 · Current $96 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: Employees were exposed to the hazard of well blowout and fire, or other emergency, while on the mokey board. Among other methods, one feasible and acceptable method to protect employees would be to install a properly rigged and secured escape line (Geronimo line) or other satisfactory auxiliary means of escape from the derrick. The condition occurred on or about May 19, 1987, 22 miles North of Refugio, Texas, O'Connor Lease Well #68, employer's Rig #10.
Recent events (2)
- · I (S) $96.00
- · Z (S) $160.00
1910.23 C01
- Issued
- Jul 13, 1987
- Abate by
- Jul 17, 1987
- Penalty
- Initial $200 · Current $120 Reduced
Recent events (2)
- · I (S) $120.00
- · Z (S) $200.00
1910.23 D01 III
- Issued
- Jul 13, 1987
- Abate by
- Jul 20, 1987
- Penalty
- Initial $120 · Current $72 Reduced
Recent events (2)
- · I (S) $72.00
- · Z (S) $120.00
1910.219 D01
- Issued
- Jul 13, 1987
- Abate by
- Jul 20, 1987
- Penalty
- Initial $80 · Current $48 Reduced
Recent events (2)
- · I (S) $48.00
- · Z (S) $80.00
1910.219 E03 I
- Issued
- Jul 13, 1987
- Abate by
- Jul 20, 1987
1910.20 G02
- Issued
- Jul 13, 1987
- Abate by
- Jul 20, 1987
1910.242 A
- Issued
- Jul 13, 1987
- Abate by
- Jul 17, 1987
1910.303 F
- Issued
- Jul 13, 1987
- Abate by
- Jul 20, 1987
More inspections in this industry (NAICS 000000)
More inspections in TX
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 100654417.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.