Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,197,549Inspections Most recent open 2026-08-27 Last loaded 2026-08-31

OSHA Inspection: MACHINE REPAIR CORP.

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of MACHINE REPAIR CORP. in 216 COLGATE AVENUE, BUFFALO, NY 14220 (NAICS 000000). OSHA activity number 100669944.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Machine Repair Corp. for free Get an email when a new federal OSHA severe-injury report for Machine Repair Corp. is published. One employer, no account, unsubscribe in one click.
Site address
216 COLGATE AVENUE
City
BUFFALO
State
NY
ZIP
14220
Inspection type
Complaint (B)
Scope
Partial (B)
Discipline
Safety
Advance notice
No
Union status
Non-union (B)
Opened
Closing conference
Case closed
Data loaded
NAICS code
000000
SIC code (legacy)
3599
Employees
15
Ownership type
Private (A)

2 citations on file for this inspection.

5(a)(1)

Serious 1 instance 1 exposed
Issued
Dec 29, 1987
Abate by
Jan 5, 1988
Penalty
Initial $1,000 · Current $500 Reduced
Section 5(a)(1) of the Occuaptional Safety and Health Act of 1970: The
employer did not furnish employment and a place of employment which were
from recognized hazards that were causing or likely to cause death or
serious physical harm to employees in that employees were exposed to:
On or about 10/2/87:
a) The hazard of being crushed which could result in serious physical
harm or death. Employee, who was removing outer eccentric bushing
from #7 Simons stone crusher, S/N 7399, main frame, while the main
frame was top side-down, was exposed to being crushed by the bushing
after the locks were removed, which permitted the bushing to drop out
of the bore.
One feasible and acceptable abatement method, among others, is to remove
the bushing while the main frame is situated in the top side-up position
as required by the manufacturer's instructions.
Recent events (2)
  • · R (S) $500.00
  • · Z (S) $1000.00

1910.179 N01

Willful 2 instances 3 exposed
Issued
Dec 29, 1987
Abate by
Jan 1, 1988
Penalty
Initial $10,000 · Current $500 Reduced
Recent events (2)
  • · R (W) $500.00
  • · Z (W) $10000.00

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 100669944.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.