DENVER, CO ·
OSHA Inspection: AUTO TECHNICIANS SERVICE
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of AUTO TECHNICIANS SERVICE in 8080 E. MISSISSIPPI AVE., DENVER, CO 80231 (NAICS 000000). OSHA activity number 100672344.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- AUTO TECHNICIANS SERVICE
- Site address
- 8080 E. MISSISSIPPI AVE.
- City
- DENVER
- State
- CO
- ZIP
- 80231
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (B)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 7538
- Employees
- 5
- Ownership type
- Private (A)
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- May 14, 1987
- Abate by
- May 17, 1987
- Penalty
- Initial $150 · Current $150
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: a) Employees were exposed to crushing injury by the inadvertant movement of hydraulic automotive lifts in that the lift in bay #1 was erratic in its raising and lowering and the lifts in bays 5 & 9 were not equipped with effectively functioning safety locks. Feasible and acceptable abatement methods, among others, to correct these hazards would be to ensure proper maintenance of hydraulic fluid/ air receiver systems and ensure proper installation and functioning of safety latching devices to support lifts at their intended use elevations as specified in American National Standards Institute (ANSI) Safety Requirements for the construction, care and use of automotive lifts, B 153.1-1974, section 3.1.10 (safety devices), section 6.1 (maintenance), and 6.3 (inspection).
More inspections in this industry (NAICS 000000)
More inspections in CO
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 100672344.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.