CONCORD, NH ·
OSHA Inspection: BONNETTE, PAGE & STONE CORP.
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of BONNETTE, PAGE & STONE CORP. in ST. JOHNS REGIONAL SCHOOL, 61 S. STATE ST., CONCORD, NH 03301 (NAICS 000000). OSHA activity number 101403095.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- BONNETTE, PAGE & STONE CORP.
- Site address
- ST. JOHNS REGIONAL SCHOOL, 61 S. STATE ST.
- City
- CONCORD
- State
- NH
- ZIP
- 03301
- Mailing
- P.O. BOX 633, 653 MAIN ST., LACONIA, NH 03246
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (N)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Last modified
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1542
- Employees
- 9
- Ownership type
- Private (A)
- Industry flags
- Construction safety.
Citations
3 citations on file for this inspection.
5(a)(1)
- Issued
- Oct 15, 1990
- Abate by
- Oct 18, 1990
- Penalty
- Initial $640 · Current $640
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to hazards of serious cuts and lacerations. A) On or about July 26, 1990, and at times prior thereto at the St. Johns Catholic school renovation project, employees were permitted to operate a Bosch electric cut-off saw with a metal diamond tipped masonry saw blade which was not recommended for use in the saw by the manufacturer. ABATEMENT: A feasible and acceptable abatement method, among others, to correct this hazard is to permit only the two types of bonded reinforced abrasive wheels recommended for use in this saw to be used, and that the saw use be limited to cutting off the applicable material recommended in the operator's manual, rather than using the saw to cut through surfaces such as masonry walls.
Recent events (2)
- · I (S) $640.00
- · Z (S) $640.00
1926.21 B02
- Issued
- Oct 15, 1990
- Abate by
- Oct 18, 1990
- Penalty
- Initial $560 · Current $560
Recent events (2)
- · I (S) $560.00
- · Z (S) $560.00
1926.405 J01 III
- Issued
- Oct 15, 1990
- Abate by
- Oct 18, 1990
More inspections at Bonnette, Page & Stone Corp.
View Bonnette, Page & Stone Corp.'s full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in NH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 101403095.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.