Safety Incidents OSHA Severe Injury Reports · 2015–2025
5,194,531Inspections Most recent open 2026-08-11 Last loaded 2026-08-14

OSHA Inspection: RUST CHECK INC.

Complaint inspection · Safety discipline

On , OSHA opened a complaint safety inspection of RUST CHECK INC. in 3080 AIRPORT HIGHWAY, TOLEDO, OH 43609 (NAICS 000000). OSHA activity number 101652410.

What this inspection record means

OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.

Watch Rust Check INC. for free Get an email when a new federal OSHA severe-injury report for Rust Check INC. is published. One employer, no account, unsubscribe in one click.
Establishment
RUST CHECK INC.
Site address
3080 AIRPORT HIGHWAY
City
TOLEDO
State
OH
ZIP
43609
Inspection type
Complaint (B)
Scope
Complete (A)
Discipline
Safety
Advance notice
No
Union status
B
Opened
Closing conference
Case closed
Data loaded
NAICS code
000000
SIC code (legacy)
7549
Employees
5
Ownership type
A

3 citations on file for this inspection.

5(a)(1)

Serious 1 instance 1 exposed
Issued
May 14, 1986
Abate by
Jun 19, 1986
Penalty
Initial $350 · Current $350
Section 5(a)(1) of the Occupational Safety and Health Act of 1970:  The
employer did not furnish employment and a place of employment which were
free from recognized hazards that were causing or likely to cause death
or serious physical harm to employees in that employees were exposed to
crushing injuries or death while working below elevated cars and trucks
on a defective car lift which could allow vehicles to fail or lower
unexpectedly:
On the Rotary Model SM-50 HR automotive lift, one support roller at the
end of the rolling bridge was displaced inward so that the shaft end was
bearing on the edge of the supporting H-beam lower flange.
This condition could cause excessive wear or deformation of the shaft
and/or flange and could result in bridge failure.
One feasible and acceptable method to correct the hazard, among other
methods, is to restore the support roller to its proper position,
replace worn or damaged parts and institute a program, of regular
inspections, maintenance and employee training to ensure that any
damage or defects is immediately corrected.

1910.22 A01

Serious 1 instance 1 exposed
Issued
May 14, 1986
Abate by
Jun 16, 1986
Penalty
Initial $200 · Current $200

1910.212 A05

Serious 1 instance 1 exposed
Issued
May 14, 1986
Abate by
Jun 2, 1986
Penalty
Initial $150 · Current $150

This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 101652410.

Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.