GREAT BEND, KS ·
OSHA Inspection: GREAT BEND COOPERATIVE ASSOCIATION
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of GREAT BEND COOPERATIVE ASSOCIATION in 606 MAIN, GREAT BEND, KS 67530 (NAICS 000000). OSHA activity number 101843498.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- GREAT BEND COOPERATIVE ASSOCIATION
- Site address
- 606 MAIN
- City
- GREAT BEND
- State
- KS
- ZIP
- 67530
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 5153
- Employees
- 17
- Ownership type
- A
Citations
7 citations on file for this inspection.
5(a)(1)
- Issued
- May 16, 1986
- Abate by
- Sep 15, 1986
- Penalty
- Initial $250 · Current $250
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to falling, crushing, & pinch point injuries. a) Falling Injuries: 1) From the bin floor of the feed mill, through openings at the southwest and southeast corner of the hoistway for the electric passenger elevator car. 2) From the first floor to the basement of grain elevator structure, through the freight elevator hoistway opening while the elevator car is being lowered to the basement floor. b) Crushing Injuries: 1) From being struck by the descending electric passenger elevator car in the Feed Mill. 2) From being struck by the descending electric freight elevator in the grain elevator structure. c) Pinch Point Injuries: 1) From having a portion of the body between the electricpassenger elevator car, and the floors, hoistway gates or supports around the elevator hoistway at the seed cleaner, bin & headhouse levels of the feed mill. 2) From having a portion of the body between the electric passenger elevator car and the floors, hoistway gates or guardrails around the elevator hoistway at the ground, bin, and distributor (headhouse) levels of the grain elevator structure. Among other methods, one feasible and acceptable abatement method to correct these hazards is to take the following steps: 1) Enclose the elevator hoistways for the two passenger elevators and the freight elevators to a height of at least 7' above each landing level. 2) Guard each elevator hoistway landing opening to the full height and width of openings at each entrance for both passenger elevators and the freight elevator. 3) Insure that the hoistway doors for both passengr elevators and the freight elevator are equipped with hoistway unit system hoistway door interlocks. 4) Insure that the two passenger elevator cars are equipped with door/gate electric contacts to prevent the elevator car from moving unless the door or gate is closed.
Recent events (3)
- · P (S) $250.00
- · I (S) $250.00
- · Z (S) $250.00
1910.212 A01
- Issued
- May 16, 1986
- Abate by
- Sep 15, 1986
- Penalty
- Initial $200 · Current $200
Recent events (3)
- · P (S) $200.00
- · I (S) $200.00
- · Z (S) $200.00
1910.23 C01
- Issued
- May 16, 1986
- Abate by
- Sep 15, 1986
Recent events (3)
- · P (O)
- · I (O)
- · Z (O)
1910.23 D01 II
- Issued
- May 16, 1986
- Abate by
- Sep 15, 1986
Recent events (2)
- · P (O)
- · Z (O)
1910.23 D01 III
- Issued
- May 16, 1986
- Abate by
- Sep 15, 1986
Recent events (3)
- · P (O)
- · I (O)
- · Z (O)
1910.219 D01
- Issued
- May 16, 1986
- Abate by
- Sep 15, 1986
Recent events (3)
- · P (O)
- · I (O)
- · Z (O)
1910.219 E03 I
- Issued
- May 16, 1986
- Abate by
- Sep 15, 1986
Recent events (3)
- · P (O)
- · I (O)
- · Z (O)
More inspections in this industry (NAICS 000000)
More inspections in KS
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 101843498.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.