MARTIN, SD —
OSHA Inspection: MUELLER FEED MILL, INC.
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of MUELLER FEED MILL, INC. in 3/4 MILE EAST OF MARTIN ON HWY 18, MARTIN, SD 57551 (NAICS 000000). OSHA activity number 102761012.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- MUELLER FEED MILL, INC.
- Site address
- 3/4 MILE EAST OF MARTIN ON HWY 18
- City
- MARTIN
- State
- SD
- ZIP
- 57551
- Mailing
- P.O. BOX 730, MARTIN, SD 57551
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- Yes
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 2048
- Employees
- 15
- Ownership type
- A
- Industry flags
- Manufacturing safety.
Citations
6 citations on file for this inspection.
5(a)(1)
- Issued
- Nov 29, 1999
- Abate by
- Jan 3, 2000
- Penalty
- Initial $1,125 · Current $1,125
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: (a) On or about 10/22/99 for employees exposed to a potential fall hazard of approximately 30 feet while attempting to gauge the amount of product in the two 2000 bushel bentonite/meal tanks. (b) For employees required to access the tops of the six 7000 bushel grain bins located on the north side of the feed mill and exposed to a potential fall hazard of approximately 24 feet. (c) For employees required to access the tops of the two 10,000 bushel grain bins located on the north side of the feed mill and exposed to a potential fall hazard of approximately 24 feet. (d) For employees required to access the tops of the two 14,000 bushel grain bins located on the north side of the feed mill and exposed to a potential fall hazard of approximately 24 feet. (e) For employees required to access the top of the one 38,000 bushel grain bin located on the north side of the feed mill and exposed to a potential fall hazard of approximately 40 feet. (f) For employees required to access the tops of the four 65,000 bushel grain bins located on the north side of the feed mill and exposed to a potential fall hazard of approximately 40 feet. Among other methods, one feasible and acceptable abatement method to correct this hazard is to install handrails on both sides of the ladder on the tops of all bins to allow employees a hand hold when the employee is required to be on the tops of the bins. Abatement Note: Abatement certification and documentation are required for this item (see enclosed "Sample Abatement Certification Letter").tion
Recent events (2)
- — I (S) $1125.00
- — Z (S) $1125.00
5(a)(1)
- Issued
- Nov 29, 1999
- Abate by
- Jan 3, 2000
- Penalty
- Initial $1,125 · Current $1,125
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: (a) For employees required to access the top of the elevator on the west side of the feed mill and exposed to a potential fall hazard of approximately 16 feet. Among other methods, one feasible and acceptable abatement method to correct this hazard is to install a self-closing gate in the guardrail on top of the elevator on the west side of the feed mill to allow safer access for employees. Abatement Note: Abatement certification and documentation are required for this item (see enclosed "Sample Abatement Certification Letter").tion
Recent events (2)
- — I (S) $1125.00
- — Z (S) $1125.00
1910.23 C01
- Issued
- Nov 29, 1999
- Abate by
- Jan 3, 2000
1910.23 C02
- Issued
- Nov 29, 1999
- Abate by
- Jan 3, 2000
- Penalty
- Initial $1,125 · Current $1,125
Recent events (2)
- — I (S) $1125.00
- — Z (S) $1125.00
1910.23 D01 III
- Issued
- Nov 29, 1999
- Abate by
- Jan 3, 2000
1910.23 D01 IV
- Issued
- Nov 29, 1999
- Abate by
- Jan 3, 2000
More inspections at Mueller Feed Mill, INC.
View Mueller Feed Mill, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in SD
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 102761012.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.