OSHA Inspection: FRANK KETTMAN DBA KETTMAN HEATING REFRIG. & AIR

Issued

Sep 14, 1989

Abate by

Sep 29, 1989

Penalty

Initial $210 · Current $210

General-duty citation text

Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The
%%
employer did not furnish employment and a place of employment which were
free from recognized hazards that were causing or likely to cause death
or serious physical harm to employees in that employees were exposed to
the hazard of electrocution when installation or repairing machinery or
equipment such as the Arrow Refrigerated Air Dryer SN11418.
In the establishement, the employer did not provide an adequate program,
nor were employees adequately trained in the recognition of hazards,
safe shut down of machines and reducing machines to zero mechanical
state as evident by the operation of replacing a compressor on the
Arrow Dryer SN11418 without locking out the electrical power source.
Among other methods, one feasible and acceptable method to correct
these hazards is to establish administrative controls and procedures
over the work being performed which will instruct workers in the
recognition of these hazards; ensure safe shutdown of machinery and
equipment by blocking, stopping or otherwise reducing to a zero
mechanical state.
Specific elements of the abatement program shall be expected to include,
but not necessarily be limited to:
1) Establish a comprehensive written procedure for lock-out which
includes procedures designed to instruct and train employees in
recognition of hazards and proper lock-out procedures.
2) Require lock-out before any maintenance, inspection, clearing,
adjusting or servicing that requires employees to enter or be in
close contact with machinery or equipment.
3) Maintain available operation and maintenance manuals on all machinery
or equipment. Assure that these manuals and other appropriate
information are provided to employees before work is begun.
4) Establish and use a documented work order system which includes
Supervisors' approval to reactivate machinery or equipment.
5) Disconnect or isolate machinery or equipment by positioning the
switch, valve or other energy isolating device so that all energy
sources (e.g. electrical, mechanical, hydraulic, etc.,) are
deactivated. Stored energy such as that in capacitors, springs,
elevated machine members, rotating flywheels, hydraulic systems and
gas, air, steam or water pressure, etc., must be dissipated or
restrained by methods such as grounding, repositioning, blocking,
bleeding, etc.
6) Require that each exposed employee lock-out the energy isolating
device with his/her personal lock.
7) Test machinery or equipment to ensure that the energy sources have
been effectively disconnected or isolated. As a precautionarymeasure
return the operating controls to the "OFF" position after the test
has been completed. NOTE: The test shall only be performed after
ensuring that no employees are exposed in the machine or equipment
area.
8) Remove locks only after ensuring the safety or all exposed
employees.
9) Train employees responsible for machinery or equipment lock-out in
all elements of the program. This training shall be repeated as
frequently as necessary to maintain management and work proficiency
and compliance with the procedure.
10) Evaluate the program periodically to ensure continued use and
adequacy.
11) Enforce all provisions of the program.

Issued

Sep 14, 1989

Abate by

Sep 29, 1989

Penalty

Initial $120 · Current $120

Issued

Sep 14, 1989

Abate by

Sep 19, 1989

Issued

Sep 14, 1989

Abate by

Oct 30, 1989

Issued

Sep 14, 1989

Abate by

Oct 30, 1989

Issued

Sep 14, 1989

Abate by

Oct 30, 1989