MORRIS, IL —
OSHA Inspection: ALUMAX MILL PRODUCTS, INCORPORATED
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of ALUMAX MILL PRODUCTS, INCORPORATED in 5555 EAST HIGHWAY 6, MORRIS, IL 60450 (NAICS 000000). OSHA activity number 103201802.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- ALUMAX MILL PRODUCTS, INCORPORATED
- Site address
- 5555 EAST HIGHWAY 6
- City
- MORRIS
- State
- IL
- ZIP
- 60450
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Y
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 3353
- Employees
- 5
- Ownership type
- A
- Industry flags
- Manufacturing safety.
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Dec 28, 1989
- Abate by
- Dec 31, 1989
- Penalty
- Initial $720 · Current $720
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees, in that: Crane operators and other employees working at the Cast House were exposed to the hazardof explosion resulting from improperly charging the gas fired furnance with cold and/or wet scrap. Among other methods, one feasible and acceptable method to correct this hazard is to establish and implement a written program in the proper handling of scrap to be melted. Such procedures shall address receiving, storage, pre-heating and charging as stupulated in the guidelines of "handling Melten Aluminum" by the Aluminum Association, Inc.
1910.37 F05
- Issued
- Dec 28, 1989
- Abate by
- Jan 30, 1990
- Penalty
- Initial $540 · Current $540
1910.1200 H
- Issued
- Dec 28, 1989
- Abate by
- Dec 31, 1989
- Penalty
- Initial $540 · Current $540
1910.212 A05
- Issued
- Dec 28, 1989
- Abate by
- Dec 31, 1989
More inspections at Alumax Mill Products, Incorporated
View Alumax Mill Products, Incorporated's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in IL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 103201802.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.