LAUREL, MS ·
OSHA Inspection: PAT MCKENZIE, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of PAT MCKENZIE, INC. in 1100 WEST DRIVE, LAUREL, MS 39440 (NAICS 000000). OSHA activity number 107094294.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- PAT MCKENZIE, INC.
- Site address
- 1100 WEST DRIVE
- City
- LAUREL
- State
- MS
- ZIP
- 39440
- Mailing
- P.O. BOX 278, ELLISVILLE, MS 39437
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Non-union (N)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1711
- Employees
- 3
- Ownership type
- Private (A)
- Industry flags
- Construction safety.
Citations
1 citation on file for this inspection.
5(a)(1)
- Issued
- Nov 27, 1996
- Abate by
- Dec 3, 1996
- Penalty
- Initial $300 · Current $300
General-duty citation text
Section 5(a)(1) of Public Law 91-596, the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees, in that employees were exposed to: falling onto electrical metallic tubing and PVC conduit. (a)Center Hallway of Main Building at proposed Nurses' Station - Employees were exposed to falling onto one-half inch diameter electrical metallic tubing (EMT) embedded into subsurface and protruding through, and 12 inches above, the concrete floor slab to serve as anchors at five (5) locations for PVC conduit for electrical/communications conductors. Among other methods, one feasible and acceptable abatement method to correct this hazard is to shorten the conduit/anchor(s) and cover with suitable guard(s).
More inspections in this industry (NAICS 000000)
More inspections in MS
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 107094294.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.