BASSFIELD, MS ·
OSHA Inspection: TRIPLE S WELL SERVICE, INC.
Accident-driven inspection · Safety discipline
At a glance
On , OSHA opened an accident-driven safety inspection of TRIPLE S WELL SERVICE, INC. in CLARANCE LOTT DRIVE, BASSFIELD, MS 39421 (NAICS 000000). OSHA activity number 107097362.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- TRIPLE S WELL SERVICE, INC.
- Site address
- CLARANCE LOTT DRIVE
- City
- BASSFIELD
- State
- MS
- ZIP
- 39421
- Mailing
- P. O. BOX 625, COLUMBIA, MS 39426
What kind of inspection was it?
- Inspection type
- Accident-driven (A)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1389
- Employees
- 5
- Ownership type
- A
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Jun 14, 1996
- Abate by
- Jul 3, 1996
- Penalty
- Initial $3,000 · Current $2,000 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The %% employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: (a)The hazard of the inability of employees of Triple S Well Service to immediately escape from the elevated tubing board, approximately 52' above the ground in the derrick of the workover Rig #3, Rig #7, and Cooper Rig, due to there being no emergency escape device. The above hazard were found at the following locations: i)Rig #3 at Bordeaux #1 Well (Greens Creek) Vintage Field, Jefferson Davis County. ii)Cooper Rig at Ollie Risher #1 Well, Gwinville Field, Jefferson Davis County. iii)Rig #7 at the Jetta Production Griffin 34-1 #1 Gwinville Field, Jefferson Davis County. Among other methods, one feasible and acceptable abatement method to correct this hazard would be the installation of a properly rigged and secured emergency descent device, or other satisfactory, auxiliary means of egress, such as specified in Section 4.7.1 of American Petroleum Institute RP-54, Gas Well Drilling and Servicing Operations: 1). Staking out a securely anchored one-half (1/2) inch wire rope escape line attached to the derrick or mast so as to provide a ready and convenient means of escape from the derrickman's work platform. 2). The escape line route is to be kept clear of obstructions at all times. 3). A safety device is to be provided to permit fast emergency exit from the derrickman's work platform to a safe place on the ground. 4). The tension on the escape line is to be periodically checked and adjusted to assure a safe landing and to allow the derrickman to stop twenty (20) to twenty- five (25) feet from the anchor. 5). The ground anchor point of the escape line is to be located a minimum lateral distance from the derrick or mast equal to the height above the ground to the point where the escape line is fastened to the derrick or mast.
Recent events (2)
- · I (S) $2000.00
- · Z (S) $3000.00
5(a)(1)
- Issued
- Jun 14, 1996
- Abate by
- Jul 3, 1996
- Penalty
- Initial $3,000 · Current $3,000
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: (a)The hazard of employees being struck by a collapsing structure. Employees working on workover rig #3 and #7 were being exposed to the hazard of a collapsing structure, due to an inadequate wind guy method. Workover Rig #3 and #7 were not setup following either the guying procedures set forth in the workover rigs owner manual, or the alternative guying procedures provided by the Johnson-Lawrence Company. The above hazards were found at the following locations: i)Rig #3 at Bordeaux #1 Well (Greens Creek) Vintage Field, Jefferson Davis County. ii)Rig #7 at the Jetta Production Griffin 34-1 #1 Gwinville Field, Jefferson Davis County. Among other methods, one feasible and acceptable abatement method to correct this hazard would be follow the recommended guying guidelines as specified in Section 8.4 of American Petroleum Institute RP-54, Gas Well Drilling and Servicing Operations.
1910.1200 E01
- Issued
- Jun 14, 1996
- Abate by
- Jul 17, 1996
1910.1200 H
- Issued
- Jun 14, 1996
- Abate by
- Jul 17, 1996
More inspections at Triple S Well Service, INC.
View Triple S Well Service, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in MS
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 107097362.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.