JONESBORO, AR —
OSHA Inspection: WHEELER BRICK COMPANY, INC.
Planned inspection · Safety discipline
At a glance
On , OSHA opened a planned safety inspection of WHEELER BRICK COMPANY, INC. in 2905 DAN AVE., JONESBORO, AR 72401 (NAICS 000000). OSHA activity number 107607996.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- WHEELER BRICK COMPANY, INC.
- Site address
- 2905 DAN AVE.
- City
- JONESBORO
- State
- AR
- ZIP
- 72401
- Mailing
- P. O. BOX 250, JONESBORO, AR 72403
What kind of inspection was it?
- Inspection type
- Planned (H)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- B
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 3251
- Employees
- 38
- Ownership type
- A
- Industry flags
- Manufacturing safety.
Citations
6 citations on file for this inspection.
5(a)(1)
- Issued
- Nov 27, 1991
- Abate by
- Dec 4, 1991
- Penalty
- Initial $875 · Current $450 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to: The hazard of being struck by a 1/2 inch diameter wire rope daily or loaded carts of brick weighing approximately 19,000 pounds are pulled from the kilns to the Stacking Area at the west track of the Packaging Area by a floor mounted wire rope and sheave system that has improperly applied, improperly spaced and an insufficient number of U-bolt clamps securing the wire rope to the brick carts. Among other methods, one feasible and acceptable method to correct this hazard is to install the U-bolt clamp with the saddle part on the line end of the wire rope, space them 3 inches apart tightening the U-bolt clamps sufficiently to prevent them from slipping together and install 3 U-bolt clamps instead of 2 clamps. The employer is not limited to abatement methods suggested by OSHA; i.e., methods explained are general and may not be effective in all cases. Other methods of abatement may be equally or more appropriate. Ultimate responsibility for determining the most appropriate abatement method rests with the employer, given its superior knowledge of the specific conditions on its worksite.
Recent events (2)
- — I (S) $450.00
- — Z (S) $875.00
1910.169 B03 II
- Issued
- Nov 27, 1991
- Abate by
- Dec 10, 1991
- Penalty
- Initial $700 · Current $350 Reduced
Recent events (2)
- — I (S) $350.00
- — Z (S) $700.00
1910.212 A01
- Issued
- Nov 27, 1991
- Abate by
- Dec 24, 1991
- Penalty
- Initial $700 · Current $350 Reduced
Recent events (2)
- — I (S) $350.00
- — Z (S) $700.00
1910.304 F05 V
- Issued
- Nov 27, 1991
- Abate by
- Dec 4, 1991
- Penalty
- Initial $700 · Current $350 Reduced
Recent events (2)
- — I (S) $350.00
- — Z (S) $700.00
1910.147 C01
- Issued
- Nov 27, 1991
- Abate by
- Dec 24, 1991
1910.1200 E01
- Issued
- Nov 27, 1991
- Abate by
- Dec 24, 1991
More inspections in this industry (NAICS 000000)
More inspections in AR
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 107607996.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.