CONCORD, NH —
OSHA Inspection: EVROKS CORP
Referral inspection · Safety discipline
At a glance
On , OSHA opened a referral safety inspection of EVROKS CORP in RT. 89, CONCORD, NH 03301 (NAICS 000000). OSHA activity number 108782046.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- EVROKS CORP
- Site address
- RT. 89
- City
- CONCORD
- State
- NH
- ZIP
- 03301
- Mailing
- P.O. BOX 737, TILTON, NH 03276
What kind of inspection was it?
- Inspection type
- Referral (C)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 1622
- Employees
- 10
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
2 citations on file for this inspection.
5(a)(1)
- Issued
- Oct 6, 1993
- Abate by
- Oct 15, 1993
- Penalty
- Initial $375 · Current $375
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The %% employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to dangers of crane failure due to the operator not adequately checking all the parameters that affect the rated lifting capacity of the crane prior to making a lift. a. Route 89, Over Clinton St., Concord, NH - The crane operator did not check all the critical parameters that affect the rated lifting capacity prior to making a near capacity lift. ABATEMENT NOTE: Among other methods, one feasible and acceptable abatement method to correct this hazard is to set up procedures that insures all critical parameters are checked prior to a lift such as but not limited to the following items: 1. Total weight to be lifted 2. Measurements of the load radius on all lifts greater than 75 of the rated capacity 3. Checks of all lifting parameters with the crane's capacity charts
1926.1053 B13
- Issued
- Oct 6, 1993
- Abate by
- Oct 12, 1993
- Penalty
- Initial $300
Recent events (2)
- — I (O)
- — Z (S) $300.00
More inspections at Evroks Corp
View Evroks Corp's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in NH
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 108782046.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.