GREEN BROOK, NJ ·
OSHA Inspection: LICCARDI MOTORS
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of LICCARDI MOTORS in 130 ROUTE 22, WEST, GREEN BROOK, NJ 08812 (NAICS 000000). OSHA activity number 108903758.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- LICCARDI MOTORS
- Site address
- 130 ROUTE 22, WEST
- City
- GREEN BROOK
- State
- NJ
- ZIP
- 08812
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Complete (A)
- Discipline
- Safety
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 5511
- Employees
- 30
- Ownership type
- A
Citations
3 citations on file for this inspection.
5(a)(1)
- Issued
- May 5, 1993
- Abate by
- Jun 7, 1993
- Penalty
- Initial $625 · Current $150 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: On or about 1/22/93, the employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of serious crushing injuries from the dropping of a "Rotary" hydraulic automotive lift while working under vehicles on the lift while the lift was below the point where the locking devices engage, without supporting the vehicle with a jack stand at each corner of the lift or equivalent means. The lifts had locking devices which could only engage when the lift was fully extended: a- One feasible means of abatement is the following: 1- Support vehicles by the use of four jack stands or equivlanent means for each vehicle under which an employee is required to work. 2- Instruct and train the employees in the proper use of the manufacturer's mechanical locking devices, were provided, and the safe operating instructions of the lifts. 3- Conduct requured maintenance procedures described in by the manufacturer. 4- Conduct the recommended inspections of the lifts by the manufacturer to ensure the locking (safety) devices and all other operaing components are in safe operating condition. Remove defective lifts from service until rendered safe for operation. 5- Post and maintain permanently on display the manufacturer's safe lifting instructions in the work area. Locations of unsafe "Rotary" lifts devices observed on 1/21/93. All of the lifts in this shop have locking devices that operate only when the lift is at full extension.
Recent events (2)
- · R (S) $150.00
- · Z (S) $625.00
1910.133 A01
- Issued
- May 5, 1993
- Abate by
- May 10, 1993
- Penalty
- Initial $375 · Current $100 Reduced
Recent events (2)
- · R (S) $100.00
- · Z (S) $375.00
1904.2 A
- Issued
- May 5, 1993
- Abate by
- May 20, 1993
Recent events (2)
- · R (O)
- · Z (O)
More inspections at Liccardi Motors
View Liccardi Motors's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in NJ
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 108903758.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.