COLUMBUS, GA —
OSHA Inspection: FIELDCREST CANNON INCORPORATED
Unprogrammed Other inspection · Safety discipline
At a glance
On , OSHA opened an unprogrammed Other safety inspection of FIELDCREST CANNON INCORPORATED in 1412 FRONT AVENUE, COLUMBUS, GA 31907 (NAICS 000000). OSHA activity number 109470856.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- FIELDCREST CANNON INCORPORATED
- Site address
- 1412 FRONT AVENUE
- City
- COLUMBUS
- State
- GA
- ZIP
- 31907
- Mailing
- P.O. BOX 180, COLUMBUS, GA 31994
What kind of inspection was it?
- Inspection type
- Unprogrammed Other (I)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Y
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 2211
- Employees
- 700
- Ownership type
- A
- Industry flags
- Construction safety.
Citations
3 citations on file for this inspection.
5(a)(1)
- Issued
- Feb 1, 1993
- Abate by
- Feb 25, 1993
- Penalty
- Initial $1,875 · Current $1,875
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to falling warps: Mill #5 Weave room #3 - Chain Hoists for warps - Spreader bars are not secured by shackles, nuts or bolts with cotter pins. Among other methods, one feasible and acceptable abatement method to correct this hazard is to replace all nuts, shackles or bolts, train all affected employees in properly securing the spreader bar after each warp change and routinely inspect the equipment to ensure that some type of locking device is being used and that established procedures are being followed.
1910.1043 L01
- Issued
- Feb 1, 1993
- Abate by
- Feb 25, 1993
- Penalty
- Initial $200 · Current $200
1910.37 Q06
- Issued
- Feb 1, 1993
- Abate by
- Feb 4, 1993
More inspections at Fieldcrest Cannon Incorporated
View Fieldcrest Cannon Incorporated's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in GA
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 109470856.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.