PENNINGTON, AL —
OSHA Inspection: JAMES RIVER CORPORATION, NAHEOLA MILL
Complaint inspection · Safety discipline
At a glance
On , OSHA opened a complaint safety inspection of JAMES RIVER CORPORATION, NAHEOLA MILL in HWY. 114, PENNINGTON, AL 36916 (NAICS 000000). OSHA activity number 109694588.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- JAMES RIVER CORPORATION, NAHEOLA MILL
- Site address
- HWY. 114
- City
- PENNINGTON
- State
- AL
- ZIP
- 36916
- Mailing
- HC 66 BOX 315, PENNINGTON, AL 36916
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Safety
- Advance notice
- No
- Union status
- Y
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 2676
- Employees
- 2000
- Ownership type
- A
Citations
4 citations on file for this inspection.
5(a)(1)
- Issued
- Jul 29, 1992
- Abate by
- Sep 1, 1992
- Penalty
- Initial $2,125 · Current $2,125
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of falling from heights ranging from approximately 10 to 40 ft., on or about May 1992: (a) The employee(s) operated the Elliot Hi-reach Bucket truck, while its hydraulic hoses were leaking. The employee(s) where inside the bucket, working at heights approximately 40 ft. Among other methods, one feasible and acceptable abatement method to correct this hazard is to repair and/or replace any leaking hydraulic hoses prior to employees operating the lift truck. Referenced in ANSI A 92.2 - 1969, Section 5. Testing and Inspection, 5.3 Installer's Responsibility. (b) The Calavar Self-Propelled Condor 66, Model# 66Q8 was pulled by a front end loader via wire rope, up ramps with slopes of greater than 14 degrees, and while an employee was inside the Condor's bucket, approximately 10 ft. in the air. Among other methods, one feasible and acceptable abatement method to correct this hazard is to slope the ramps to no more than 14 degrees, as stated in the manufacturer's operating manual. Referenced in the manufacturer's operating manual.
Recent events (2)
- — F (S) $2125.00
- — Z (S) $2125.00
1910.67 C02 I
- Issued
- Jul 29, 1992
- Abate by
- Sep 1, 1992
- Penalty
- Initial $2,125 · Current $2,125
Recent events (2)
- — F (S) $2125.00
- — Z (S) $2125.00
1910.67 C02 V
- Issued
- Jul 29, 1992
- Abate by
- Aug 14, 1992
- Penalty
- Initial $2,125 · Current $2,125
Recent events (2)
- — F (S) $2125.00
- — Z (S) $2125.00
1910.67 C02 IX
- Issued
- Jul 29, 1992
- Abate by
- Sep 1, 1992
- Penalty
- Initial $2,125 · Current $2,125
Recent events (2)
- — F (S) $2125.00
- — Z (S) $2125.00
More inspections at James River Corporation, Naheola Mill
View James River Corporation, Naheola Mill's full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in AL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 109694588.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.