BROOKSVILLE, FL —
OSHA Inspection: AG VENTURE, INC.
Complaint inspection · Health discipline
At a glance
On , OSHA opened a complaint health inspection of AG VENTURE, INC. in 27413 SOULT ROAD, BROOKSVILLE, FL 34602 (NAICS 000000). OSHA activity number 109712141.
OSHA opens inspections for many reasons — routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- AG VENTURE, INC.
- Site address
- 27413 SOULT ROAD
- City
- BROOKSVILLE
- State
- FL
- ZIP
- 34602
- Mailing
- 17109 AYERS ROAD, BROOKSVILLE, FL 34602
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Health
- Advance notice
- No
- Union status
- N
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 0252
- Employees
- 25
- Ownership type
- A
Citations
7 citations on file for this inspection.
5(a)(1)
- Issued
- Jul 6, 1993
- Abate by
- Jul 23, 1993
- Penalty
- Initial $1,500 · Current $800 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of electric shock. (a) Near the Egg Storage Room; the ground prong was missing from the plug of a Milwaukee 7 1/4 inch circular saw, operating at 110 volts AC; (b) Egg Packing Room, which is a damp location; the wire insulation was frayed and the ground prong was missing from the plug of a Dayton circulating fan, operating at 110 volts Ac; (c) Egg Packing Room near the conveyor belt, which is a damp location; the door to the switch panel for the egg packing machines and conveyor would not stay closed, exposing employees to live electrical parts of at least 110 volts AC. Among other methods, one feasible and acceptable method to correct this hazard is to replace the defective wiring and plugs, and to repair the electrical panel
Recent events (2)
- — I (S) $800.00
- — Z (S) $1500.00
5(a)(1)
- Issued
- Jul 6, 1993
- Abate by
- Jul 23, 1993
- Penalty
- Initial $375 · Current $250 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employee(s) were exposed to falls from heights of over four (4) feet to the ground. (a) Open-sided platforms outside of each of the three (3) laying houses; employees stand at the edge of the open-sided platforms to toss dead chickens into wheel barrows. Among other methods, one feasible and acceptable method to correct this hazard is to install standard guardrails on each platform.
Recent events (2)
- — I (S) $250.00
- — Z (S) $375.00
5(a)(1)
- Issued
- Jul 6, 1993
- Abate by
- Jul 23, 1993
- Penalty
- Initial $300 · Current $250 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: The employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employee(s) were exposed to injury from unguarded chains and sprockets. (a) Egg Packing Room, at the Diamond Egg Packer with a Choretime conveyor; a female employee who had long hair and who wore loose fitting clothe was exposed to the hazard of becoming entangled in unguarded chains and sprockets. (b) Laying Houses, at the end of Big Dutchman feed conveyors; employees who must pass through an 18" - 22" space between feed conveyor drive units are exposed to the hazard of having their clothing entangled in unguarded chains and sprockets. Among other methods, one feasible and acceptable method to correct this hazard is to install guards which will enclose the chain and sprocket drive
Recent events (2)
- — I (S) $250.00
- — Z (S) $300.00
1903.2 A01
- Issued
- Jul 6, 1993
- Abate by
- Jul 9, 1993
- Penalty
- Initial $150 · Current $150
1904.2 A
- Issued
- Jul 6, 1993
- Abate by
- Jul 23, 1993
1910.1200 G01
- Issued
- Jul 6, 1993
- Abate by
- Aug 9, 1993
1910.1200 H
- Issued
- Jul 6, 1993
- Abate by
- Aug 9, 1993
More inspections in this industry (NAICS 000000)
More inspections in FL
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). The original IMIS detail view is available at OSHA's Establishment Search for activity number 109712141.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.