WATCHUNG, NJ ·
OSHA Inspection: SEARS ROEBUCK & COMPANY, INC.
Complaint inspection · Health discipline
At a glance
On , OSHA opened a complaint health inspection of SEARS ROEBUCK & COMPANY, INC. in 1640 ROUTE 22, WATCHUNG, NJ 07060 (NAICS 000000). OSHA activity number 114039399.
OSHA opens inspections for many reasons: routine scheduling under a national or local emphasis program, an employee complaint or referral, or a follow-up after a reported injury. Opening or conducting an inspection is not itself an allegation or a finding that this employer broke any rule; any findings appear as the citations listed below, and citations can be contested, reduced, or withdrawn.
Where did this inspection happen?
- Establishment
- SEARS ROEBUCK & COMPANY, INC.
- Site address
- 1640 ROUTE 22
- City
- WATCHUNG
- State
- NJ
- ZIP
- 07060
What kind of inspection was it?
- Inspection type
- Complaint (B)
- Scope
- Partial (B)
- Discipline
- Health
- Advance notice
- No
- Union status
- Non-union (N)
When did the case open and close?
- Opened
- Closing conference
- Case closed
- Data loaded
Establishment context
- NAICS code
- 000000
- SIC code (legacy)
- 5311
- Employees
- 200
- Ownership type
- Private (A)
Citations
10 citations on file for this inspection.
5(a)(1)
- Issued
- Jan 13, 1992
- Abate by
- Feb 27, 1992
- Penalty
- Initial $5,000 · Current $3,000 Reduced
General-duty citation text
Section 5(a)(1) of the Occupational Safety and Health Act of 1970: On or about 10/11/91, the employer did not furnish employment and a place of employment which were free from recognized hazards that were causing or likely to cause death or serious physical harm to employees in that employees were exposed to the hazard of serious crushing injuries from the dropping of rotary hydraulic automotive lifts while employees were working under vehicles on the lifts. Of the eleven lifts in the service area, five had locking devices which did not engage. The locking devices were inoperable due to excessive ac- cumulations of dirt, rust and oil in the latch mechanism. Also, the locking devices on these lifts could only be engaged when the lift is fully extended: a- Some feasible and reasonable abatement methods are, among others: 1- When working under a lift that is not fully extended and locked, use found jack stands or equivalent means for a positive means of support. 2- Instruct and train employees in the proper use of the manufacturer's mechanical locking devices and safe operating instructions for the lifts. 3- Conduct required maintenance procedures described by the manufacturer. 4- Conduct the recommended inspections of the lift by the manufacturer to ensure that the mechanical locking devices and all other components are in safe operating condition. Remove defective lifts from service until they are rendered safe for use. 5- Post and maintain permanently on display the manufacturer's safe lifting instructions in the lift area. 6- Follow the requirements of ANSI B153.1 and the Automotive Lift Institute publications, ALI-SM89-1 (Lifting it Right). Note: The lifts with inoperable locking devices were located in Bays 3, 4, 6, 7 and 8. Condition noted on or about 10/11/91.
Recent events (2)
- · I (S) $3000.00
- · Z (S) $5000.00
1910.36 B04
- Issued
- Jan 13, 1992
- Abate by
- Jan 16, 1992
- Penalty
- Initial $5,000 · Current $3,000 Reduced
Recent events (2)
- · I (S) $3000.00
- · Z (S) $5000.00
1910.215 A04
- Issued
- Jan 13, 1992
- Abate by
- Jan 16, 1992
- Penalty
- Initial $1,500 · Current $900 Reduced
Recent events (2)
- · I (S) $900.00
- · Z (S) $1500.00
1910.242 A
- Issued
- Jan 13, 1992
- Abate by
- Jan 16, 1992
- Penalty
- Initial $3,500 · Current $2,100 Reduced
Recent events (2)
- · I (S) $2100.00
- · Z (S) $3500.00
1910.1200 E01
- Issued
- Jan 13, 1992
- Abate by
- Feb 13, 1992
- Penalty
- Initial $2,500 · Current $1,500 Reduced
Recent events (2)
- · I (S) $1500.00
- · Z (S) $2500.00
1910.1200 G08
- Issued
- Jan 13, 1992
- Abate by
- Feb 13, 1992
- Penalty
- Initial $2,500 · Current $1,500 Reduced
Recent events (2)
- · I (S) $1500.00
- · Z (S) $2500.00
1910.1200 H02 III
- Issued
- Jan 13, 1992
- Abate by
- Feb 13, 1992
- Penalty
- Initial $2,500 · Current $1,500 Reduced
Recent events (2)
- · I (S) $1500.00
- · Z (S) $2500.00
1904.2 A02
- Issued
- Jan 13, 1992
- Abate by
- Jan 21, 1992
- Penalty
- Initial $1,000 · Current $600 Reduced
Recent events (2)
- · I (O) $600.00
- · Z (O) $1000.00
1904.4
- Issued
- Jan 13, 1992
- Abate by
- Jan 21, 1992
- Penalty
- Initial $1,000 · Current $600 Reduced
Recent events (2)
- · I (O) $600.00
- · Z (O) $1000.00
1904.5 C
- Issued
- Jan 13, 1992
- Abate by
- Jan 21, 1992
- Penalty
- Initial $1,000 · Current $600 Reduced
Recent events (2)
- · I (O) $600.00
- · Z (O) $1000.00
More inspections at Sears Roebuck & Company, INC.
View Sears Roebuck & Company, INC.'s full OSHA safety record →
More inspections in this industry (NAICS 000000)
More inspections in NJ
Source
This record is reproduced from the U.S. Department of Labor Open Data API (OSHA inspection dataset). OSHA publishes its own view of this case as inspection number 114039399.
Look up any company's OSHA accident reports by company, or browse severe injury reports by year, state, and company.